Table of Contents
Advertisement
Auger Control
Refer to the Assembly section for instructions on adjusting the auger control cable.
Skid Shoes
Refer to the Assembly section for instructions on adjusting the skid shoes.
Belt Replacement
Auger Belt
To remove and replace your snow thrower's auger belt, proceed as follows:
1.
To prevent spillage, remove all fuel from tank by running engine until it
stops.
2.
Remove the plastic belt cover on the front of the engine by removing the two
self-tapping screws. See Figure 28.
3.
Roll the auger belt off the engine pulley. See Figure 29.
4.
Carefully pivot the snow thrower up and forward so that it rests on the auger
housing.
5.
Remove the frame cover from the underside of the snow thrower by
removing four self-tapping screws which secure it. See Figure 30.
SERVICE AND MAINTENANCE
Figure 30
22
Figure 28
Figure 29
Advertisement
Chapters
Table of Contents
