SofTec Microsystems EVB9S12XEP100 Quick Start Manual

EVB9S12XEP100
Quick Start Guide

0. Introduction

This quick start guide will walk you through setting up your evaluation board, connecting it to the PC, and
launching the provided example. For more information, please read the board user's manual.

1. Run the Factory Programmed Example (Standalone Mode)

In standalone mode, no PC connection is required. The microcontroller is factory programmed with a sample
application.
To run the built-in example:
1. Ensure that all of the jumpers in the "INPUTS" and "OUTPUTS" sections are inserted.
2. Power the board. The power connector accepts 12 V DC wall plug-in power supply with a 2.1 mm pin and
sleeve plug with positive in the center and sleeve as ground. The green "POWER" LED on the board should
turn on.
3. Press the "PB4" push-button. The output of the light sensor will be displayed on the two dot-matrix displays,
in a graphical way. The light sensor is placed on the left of the "PB7" push-button. Cover the sensor with a
finger and see the effect on the displays.
4. Press the "PB5" push-button. The output of the light sensor will be displayed on the two dot-matrix displays,
in a numerical (hexadecimal) way.
5. Press the "PB6" push-button. The value of the "PAD10" potentiometer will be displayed on the two dot-matrix
displays, in a graphical way.
6. Press the "PB7" push-button. The value of the "PAD10" potentiometer will be displayed on the two dot-matrix
displays, in a numerical (hexadecimal) way.

2. Host Mode

The same example above can be run from the host PC. To do this, the CodeWarrior Development Tools and the
SofTec Microsystems Additional Components must be installed first.

Install CodeWarrior Development Studio

To install the CodeWarrior Development Studio, insert the CodeWarrior CD-ROM into your computer's CD-ROM
drive. A startup window will automatically appear. Follow the on-screen instructions.

Install SofTec Microsystems Additional Components

The SofTec Microsystems Additional Components install all of the other required components to your hard drive.
These components include:
The Evaluation board's USB driver;
The software plug-in for CodeWarrior;
Examples;
Evaluation board user's manual;
Evaluation board schematic;
Rev. 2.0