Table of Contents
Advertisement
Setup
Important: Remove and discard the protective plastic
sheet that covers the engine.
1
Installing the Blade-control
Bar
No Parts Required
Procedure
Install the blade-control bar into the upper handle (Figure 3).
2
Installing the Handle
No Parts Required
Procedure
WARNING
Folding or unfolding the handle improperly can
damage the cables, causing an unsafe operating
condition.
• Do not damage the cables when folding or
unfolding the handle.
• If a cable is damaged, contact an Authorized
Service Dealer.
1. Remove the handle knobs from the machine housing
(Figure 4).
Figure 3
Important: Route the cables to the outside of the
handle knobs as you install the handle.
2. Move the handle to the operating position.
3. Install and tighten the handle knobs that you removed
in step 1.
3
Installing the Recoil-starter
Rope in the Rope Guide
No Parts Required
Procedure
Important: To start the engine safely and easily
whenever you use the machine, install the recoil-starter
rope in the rope guide.
Pull the recoil-starter rope through the rope guide on the
handle (Figure 5).
5
Figure 4
Advertisement
Table of Contents
