Table of Contents
Advertisement
6 - ELECTRICAL INSTALLATION
IMPORTANT: The appliance must be installed in accordance with the manufacturer's
instructions. Incorrect installation, for which the manufacturer accepts no
responsibility, may cause damage to persons, animals or property.
The connection of the appliance to earth is mandatory. The manufacturer declines
all responsibility for any inconvenience resulting from the inobservance of this
condition.
Before carrying out any work on the electrical parts of the appliance, the appliance
must be disconnected from the mains.
FOR YOUR SAFETY PLEASE READ THE FOLLOWING INFORMATION:
This appliance must be installed by a qualified technician according to the current local
regulations and in compliance with the manufacturer instructions.
This appliance is supplied with a moulded 13 amp three pin mains plug with a 3 amp fuse
fitted. Should the fuse require replacement, it must be replaced with a fuse rated at 3 amp
and approved by ASTA or BSI to BS 1362.
The plug contains a removable fuse cover that must be refitted when the fuse is replaced.
In the event of the fuse cover being lost or damaged, the plug must not be used until a
replacement cover has been obtained. Replacement fuse covers can be purchased from
your nearest electrical dealer and must be the sarne colour as the original.
IF THE MOULDED MAINS PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR
HOME OR IS REMOVED FOR ANY OTHER REASON, THEN THE FUSE SHOULD BE
REMOVED AND THE CUT OFF PLUG DISPOSED OF SAFELY TO PREVENT THE
HAZARD OF ELECTRIC SHOCK.
THERE IS A DANGER OF ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED
INTO ANY 13 AMP SOCKET OUTLET.
If a replacement plug is to be fitted, please observe the wiring code shown below.
Warning! This appliance must be earthed.
A properly earthed three pin plug (fused at 3 amps, to BS 1362 ASTA approved) must be
used. As the colours of the wires in the mains lead of this appliance may not correspond with
the coloured markings identifying the terminals
in your plug, proceed as follows:
•
The wire which is coloured GREEN &
YELLOW must be connected to the
terminal in the plug which is marked with
letter "E" or by the Earth symbol "
coloured GREEN & YELLOW.
•
The wire which is coloured BLUE must be
connected to the terminal which is marked
with the letter "N" or coloured BLACK.
•
The wire which is coloured BROWN
must be connected to the terminal which
is marked with the letter "L" or coloured
RED.
Green & Yellow
Earth
" or
Blue Neutral
Fig. 10.1
3 amp fuse
Brown Live
23
Advertisement
Table of Contents
