Craftsman 31AM2T6D799 Operator's Manual page 8

Installing the Chute
1. Remove the hex washer screws in the chute base. See Figure 4.
Hex Washer
Screw
2. Align the holes in the chute base with the holes in the lower chute
and secure with the previously removed hex washer screws. See
Figure 5.
ASSEMBLY
Figure 4
Figure 5
Installing the Chute Rotation Control Assembly
1. Remove the four hex washer screws from the back of the handle
(two on each side). See Figure 6.
2. Using the four hex washer screws, install the chute rotation
control assembly. See Figure 7.
8
Figure 6
Figure 7