Table of Contents
Advertisement
Quick Links
SAFETY PRECAUTIONS
WARNING –
ELECTRIC SHOCK OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
A. Use this unit only in the manner intended
by the manufacturer. If you have questions,
contact the manufacturer.
B. Before servicing or cleaning unit, switch
power off at service panel and lock the service
disconnecting means to prevent power from
being switched on accidentally. When the
service disconnecting means cannot be locked,
securely fasten a prominent warning device,
such as a tag, to the service panel.
C. Do not use this unit with any solid-state speed
control device.
D. Use with approved cord-connection kit only.
E. This unit must be grounded.
ge.com
49-80421
06-06 JR
Use and Care & Installation Guide
Safety Instructions
Operating Instructions
Automatic Heat Sensor ...........................3
Controls .....................................................2
Cleaning
....................................................
Filter............................................................3
Light Bulb Replacement..........................3
IMPORTANT SAFETY INFORMATION.
READ ALL INSTRUCTIONS BEFORE USING.
TO REDUCE THE RISK OF FIRE,
30 " Vented Hood
...Front Cover, 2
.........2, 3
3
WARNING –
RANGE TOP GREASE FIRE:
A. Never leave surface units unattended at high
settings. Boilovers cause smoking and greasy
spillovers that may ignite. Heat oils slowly on
low or medium settings.
B. Always turn hood ON when cooking on high
heat or when flambeing food (i.e., Crepes
Suzette, Cherries Jubilee, Peppercorn Beef
Flambé).
C. Clean ventilating fans frequently. Grease should
not be allowed to accumulate on fan or filter.
D. Use proper pan size. Always use cookware
appropriate for the size of the surface
element.
Models: JV394 JV395 JV396 JV930
Installation
.....................................4–6
Damper/Duct Connector .........................5
Electrical Wiring .......................................6
Filter Panel.............................................3, 5
Mounting Brackets...................................5
Consumer Support
Important Phone Numbers...Back Cover
Warranty ....................................................7
TO REDUCE THE RISK OF A
(continued next page)
....Back Cover
Advertisement
Table of Contents
Related Manuals for GE JV395
Summary of Contents for GE JV395
- Page 1 C. Do not use this unit with any solid-state speed appropriate for the size of the surface control device. element. D. Use with approved cord-connection kit only. (continued next page) E. This unit must be grounded. ge.com Models: JV394 JV395 JV396 JV930 49-80421 06-06 JR...
- Page 2 IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. SAFETY PRECAUTIONS CAUTION – WARNING – FOR GENERAL VENTILATING USE ONLY. TO REDUCE THE RISK OF FIRE, DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE ELECTRIC SHOCK OR INJURY TO PERSONS, OBSERVE THE MATERIALS AND VAPORS.
-
Page 3: Automatic Heat Sensor
If the ends of the tube light but the center does not, National Parts Center1.800.626.2002 the starter may require replacement. The starter is located behind the filter panel on the right hand side. ge.com... -
Page 4: Installation Instructions
INSTALLATION INSTRUCTIONS WORKSHEET—CALCULATE TOTAL TOOLS YOU WILL NEED EQUIVALENT DUCTWORK LENGTH Flat blade and Phillips Pencil DUCT EQUIVALENT NUMBER screwdrivers Duct tape PIECES LENGTH X USED = TOTAL ″ x 10″ ⁄ 1 Ft. Rect., Metal Snips Electric Drill straight (in some applications) Saw (saber or keyhole) ″... - Page 5 INSTALLATION INSTRUCTIONS 2. Attach the damper/duct connector. 7. Install the mounting brackets. FRONT OF HOOD Insert the bent end of the installation rod into the Use two (2) screws (provided) to attach the connector access hole in the housing. to the housing. The damper flap should open in the direction indicated by the arrow.
- Page 6 INSTALLATION INSTRUCTIONS 12. Connect the electrical wiring. Remove the wire box cover. Attach the power cable to the hood using the proper connector. Connect black to black, white to white and green or bare wire to ground screw. Replace the wire box cover. Insert two (2) screws, short or long as appropriate, through the control box and into the other mounting CAUTION: DO NOT TURN THE BREAKER...
-
Page 7: Warranty
Customer Care ® technician. To schedule service, on-line, 24 hours a day, visit us at ge.com, or call 800.GE.CARES (800.432.2737). Please have serial number and model number available when calling for service. • Service trips to your home to WHAT IS NOT COVERED •... -
Page 8: Consumer Support
Contact Us ge.com If you are not satisfied with the service you receive from GE, contact us on our Website with all the details including your phone number, or write to: General Manager, Customer Relations GE Appliances, Appliance Park...