Advertisement
Installing the Wire
Harnesses
1. Wire harness installed on TX 427
1.
Install the post connectors from the port wire
harness to the posts on the 12 V receptacle.
1. Negative (-) connector
2. Negative (-) post
2.
Connect the port wire harness to an outgoing
power connector (end with 2 connectors) of the
splitter harness.
Figure 7
3. Positive (+) connector
4. Positive (-) post
Figure 6
2. Wire harness installed on TX 525
1. Port wire harness
2. Outgoing power
connectors
g311406
3.
Connect the other end of the splitter harness to
an accessory connector on the machine wire
harness.
Note:
If no connectors are open on the machine
wire harness, unplug an accessory from the
machine wire harness and plug it into the other
outgoing power connector of the splitter harness.
4.
For the TX 525, install the fuse panel.
Note:
Reverse the procedure for
Fuse Panel (page
5.
Close the hood.
3
Figure 8
3. Splitter harness
4. Accessory connector of
machine wire harness
Removing the
1).
g333594
g331130
Advertisement
