Aquadistri SuperFish Aqua Pro Feeder Quick Start Manual

GB - SuperFish Aqua Pro Feeder
Important
• Read carefully before usage.
• Only suitable for indoor use.
• Open battery cover and insert 3 AA (1.5V Alkaline batteries) and close
the cover.
• Do NOT use rechargeable batteries.
• Replace the batteries when the battery indicator on the display shows
only one dash. The feeder will otherwise stop feeding at short notice.
However, the programmed settings will be retained.
• Always remove the batteries when you are not using the Aqua Pro
Feeder for a longer period.
Setting and programming
Program the Aqua Pro Feeder before placing it on your aquarium.
To switch the feeder on (or off), press the On/Off button for a long time
(± 3 sec.). This is a safeguard against accidentally switching the feeder
on or off.
Amount of feed
1 2 3
1 07:30
2 12:15
3 18:45
Di erent feeding times
Manual feed/ Setting
Feed quantity
Clock setting
• Press the Set button and the current time "00:00" will flash, press the
HR button to set the hours.
• Press the MIN button to set the minutes.
• Press the Set button if you want to set the feeding times right away.
Programming feeding times
Up to three feeding times per day can be programmed and up to six
different feed quantities can be given per feeding session.
: ± 300 mg, : ± 450 mg,
: ± 3500 mg feed (depending on the specific weight of the feed).
• Press 2x the Set button (or continue immediately after clock settings)
and the top of the three feeding times will start flashing " 00:00"
• Press the HR button to set the hours and the MIN button to set the
minutes of the first feeding time.
• Press the Manual feed/Feed quantity button
of feed.
Advice: Start with the lowest feed quantity setting
increase it when it is clear that the fish are eating the feed fast
enough.
• Press the Set button again to set the next feeding time " 00:00"
and feed quantity ( , ,
• Repeat the above steps for the third feeding time " 00:00".
• If you do not want to feed, make sure no feed quantity setting is selected.
• Then press the Set button to finalise everything.
Current time
4 5 6
08;36
Battery level
Hours Minutes On/O
: ± 150 mg,
: ± 900 mg, : ± 1800 mg and
to set the quantity
and only
, etc.).
Manual feeding
By pressing the Manual feed/Feed quantity button
container will feed once for 10 seconds.
Installing the Aqua Pro Feeder onto the aquarium
The feeder can be installed on the aquarium using the bracket or the
Velcro tape.
• Clamp the bracket over the bottom of the feeder. To do this, press the
clamp so that it falls over the two recesses on the bottom of the
feeder.
• The bracket can be rotated 360°, so you can always turn the feeder to
the desired position.
• Attach the bracket over the edge of the aquarium and carefully
tighten the screws so that the feeder is firmly in place.
• Make sure the opening of the feeder hangs above the aquarium so
that the feed goes directly into the water.
• When using the Velcro tape, stick one part of the Velcro tape to the
bottom of the feeder and the other to the desired surface.
Make sure the Aqua Pro Feeder doesn't get wet or drops into the
aquarium. Water damage is not covered by the warranty!
Filling the Feed container
The Aqua Pro Feeder is suitable for pellets or sticks up to 3 mm.
• Simply fill the container via the lid at the top. After filling, close the lid.
• Press thee Manual feed button
of the feeder so that the feeder can feed directly at the set feeding
times.
Maintenance
• Always remove leftover feed and dirt and clean the feed container
regularly.
• Do NOT use soap or detergents.
• Make sure the container is completely dry before adding feed.
Warranty conditions
1 year manufacturer's warranty on materials and construction defects. Devices
must be returned complete with all components, accompanied with an official
proof of purchase confirming a purchase date for any warranty claims. Incomplete
devices of which parts are missing, and devices without proof of purchase are not
eligible for warranty. After receiving and checking, we will determine whether the
device will be repaired or replaced. For a device repaired or replaced under
warranty, the remaining time of the original warranty period applies. Carefully
read the instructions on installation, use and maintenance. Damage due to
incorrect use, damage due to contamination or not cleaning the device are not
covered by the warranty. Always keep the proof of purchase, without proof of
purchase the warranty will be void!
Recycling
This symbol indicates that this product (if it is discarded) may not be disposed of
with normal household waste. Instead it must be handed in at an official collection
centre (e.g. HWRC). Or can be returned to the dealer when purchasing a similar new
product. Follow the applicable rules in your country for the separate collection of
electrical and electronic products. Separate collection and recycling are better for
the environment, public health and reduces waste.
Vlietweg 8, NL-4791 EZ Klundert The Netherlands
www.aquadistri.com
, the feed
to transport the feed to the front