Table of Contents
Advertisement
MGSP18LI par Mac Allister
Troubleshooting
Suspected malfunctions are often due to causes that the users can
fix themselves. Therefore check the product using this section. In
most cases the problem can be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair
work must be performed by an authorised service centre or
a similarly qualified specialist if you cannot solve the problem
yourself!
Problem
1.
Product
does not start
2.
Product
does not reach
full power
3.
Unsatisfactory
result
Possible cause
1.1. Battery pack not
properly attached
1.2. Battery pack
discharged
1.3. Battery pack
damaged
1.4. Other electrical defect
to the product
2.1. Battery pack capacity
too low
2.2. Air vents are blocked
3.1. Saw blade is worn/
damaged
3.2. Saw blade not
suitable for work piece
material
Troubleshooting
Solution
1.1. Attach properly
1.2. Remove and
charge battery pack
1.3. Replace with a new
one of the same
1.4. Check by a
specialist electrician
2.1. Charge battery
pack
2.2. Clean the air vents
3.1. Replace with a new
one
3.2. Use proper saw
blade
EN
33
Advertisement
Table of Contents
