Advertisement
Enabling Telephones or Terminals in DSC
Panels
From your phone shop download the User application
"Garnet Control Pro".
Once you have downloaded the application you will
need to register using your personal details.
Then within the application press the "+" button.
to add a new system.
You must tick the option that you have a DSC alarm
panel.
You must then initiate the connection to your phone
from the communicator. You have to press the
"AP ENABLED" button 3 times in a row or if you have
a keypad, press the "AP ENABLED" button 3 times in a
row.
] + 8 + 7.
LCD press [
Confirmation of successful enablement will be by
flashing the top 4 antenna and communications
indication LEDs. After this press the "Verify" button
on your mobile phone.
In seconds your application will be ready for use.
Note: The Garnet Control application allows up to 20
total users to be associated.
Each user that registers in the app can have a different
user code that must be previously loaded in the alarm
panel.
If each user is configured with a different code, this will
be identified in the event memory, and the user
responsible for arming and/or disarming can be
identified.
Garnet Programmer Programming Videos In the
following QR Code you will find all the necessary
information for the programming of the Garnet
Programmer and its respective alarm panel.
If you are unable to program the devices, you will be
able to see the following intuitive information.
In the following QR Code you will find all the informa-
tion you need to link phones to your alarm system.
In such a case, if the equipment cannot be pro-
grammed, the following may be done
see the following intuitive information.
Download
Click here
Video Garnet Programmer
Reset the communicator configuration to factory
defaults.
To reset the communicator to factory defaults, the
"AP ENABLED" button must be pressed for more than
6 seconds, until all antenna and communications LEDs
flash together.
Remote Control with 3G-COM-G/IP-500G Communi-
cators
The above-mentioned models are allowed to control
by different means. In principle, 3G-COM-G communica-
tors allow communication via mobile data, WiFi net-
works and text messaging (SMS), while IP-500G commu-
nicators allow communication only via WiFi networks.
This allows the panels to be controlled
via mobile applications and/or SMS (Messaging
traditional text)
All modes are explained individually in the following
sections.
Remote Control with 3G-COM-G/ IP-500G Communicators via
Garnet Control APP
Control of the panels will be performed by any of the above mentioned
communicators via the Garnet Control APP using the Internet. This
means that both 3G-COM-G/IP-500G communicators must have stable
connectivity to the Internet by any possible means of operation as well
as your mobile phone.
You should proceed to associate your mobile device with the App, if you
are an Administrator or Owner of the panel you should consult the "En-
abling Phones" section of the installer's manual or contact your installer
and/or monitoring company.
If you are an Administrator or Owner and would like to invite more users
to control your system, you should contact
within the application to the Community tab and invite the remaining
users.
Click here
5
Advertisement
