Advertisement
5) Once ready, open the Garnet Programmer application
and follow the instructions you wish to program.
Note: In programming the communicator within the
"status" screen you should make a note of the System
Number as it will be used in the next step.
Enabling Telephones or Terminals
To enable the phones, you must first ensure that the
communicator was previously configured and has a
successful connection to the internet through a Wifi
connection or by using mobile data.
From your phone shop download the User
application "Garnet Control Pro".
Once you have downloaded the application you will
need to register using your personal details.
Then within the application press the "+" button.
to add a new system.
You must enter the System Number obtained in
the previous step, a name that identifies the alarm
system that is installed and finally an icon.
You must then initiate the connection to your phone
from the communicator. Press the "AP ENABLED"
button 3 times in a row or if you have an LCD keypad
] + 8 + 3. Confirmation of successful
press [
enablement will be by flashing the 2 LEDs.
antenna and communications indication. Then press the
"Verify" button on your mobile phone.
In seconds your application will be ready for use.
Note: The Garnet Control application allows up to 20
total users to be associated.
The main user that was associated will be listed as "
Administrator".
This user will be able to invite the remaining 19 users of
the system with two different user categories:
• Primary User: This user can be defined by the
administrator in terms of the functions and permissions
he/she has over the alarm panel.
For example: You can have a user as a Family member
who has all remote control and event receiving
functions checked.
But I can also have a main user that only allows him to
receive events.
4
Download
Click Here
• Secondary User: This user does not allow attribute
modifications. Only this user can view system cameras.
To invite users, go to the community tab.
Communicator programming / Alarm panel (DSC)
Programming the Communicator and Panel from the
Garnet Programmer app
The communicator is programmed via the
"Garnet Programmer" app. This app also allows the
Garnet alarm panels to be programmed.
To download the programming app, scan the following
QR codes as appropriate or search the download shop
for the Garnet Programmer app.
Follow the steps below:
1) Press the button on the board indicating
"AP ENABLE".
or, if you have an LCD keypad, press [
+ This will cause the communicator to generate a WiFi
network for a period of 5 minutes.
2) Search your phone for available WiFi networks and
connect to the WiFi network whose name is
"IP-500Gxxxxxx".
3) Enter the default network password: admin1234.
4) Once the communicator enters programming mode.
The LEDs will behave as follows:
Antena Wifi
Signal 1-5
No Signal
If this result is not achieved. Repeat the steps from the
beginning.
5) Once ready, open the Garnet Programmer application
and follow the instructions you wish to program.
Download
Click Here
]
Comunic Wifi
ACK
NAK
Advertisement
