Recall Mode; Dial Mode; Change Base Pin Code; Registering An Additional Handset - Motorola T101 Instructions Manual

8.4

Recall mode

This setting is useful to access certain network and PABX/switchboard services.
The default recall time is suitable for your country and network operator. It is unlikely that
you should need to change this setting unless advised to do so.
m
1. Press , scroll
d
2. Scroll to RECALL TIME
u d
3. Press or to select SHORT,
8.5

Dial mode

Your T1 is set to tone dialling. You should only need to change this if connected to an older
type of switchboard / PBX which requires pulse dialling.
m
1. Press , scroll
d
2. Scroll to DIAL MODE
u d
3. Press or to select
8.6

Change base PIN code

Some functions are protected by a 4 digit PIN code which must be entered if you want to
change the settings. The default PIN is 0000. You can change this to your own preferred
number.
When you enter a PIN, the digits are shown as ****.
m
1. Press , scroll
d
2. Scroll to CHANGE PIN
3. The display shows
4. The display shows CONFIRM. Re-enter the new PIN and press
IMPORTANT
If you change the PIN code, please keep a record of the new number.
8.7

Registering an additional handset

You can register up to 4 handsets to your T1 base to extend your phone system without
having to install extension sockets for each new phone.
If you have purchased a T1 multiple pack, all additional handsets come pre-registered to
the base.
If you have purchased an additional handset separately, you must register it to your T1 base
before it can be used.
NOTE
Handset batteries must be fully charged before you start to register. Hold your handset
close to the base during the registration process.
Base settings
d
to ADVANCED SET
m
and press
MEDIUM
d
to ADVANCED SET
m
and press
TONE or PULSE
d
to ADVANCED SET
m
and press
NEW -- -- -- -- , enter the new 4 digit PIN code and press
m
and press .
.
or LONG and press
m
and press .
.
m
and press to con rm.
m
and press .
.
m
to con rm.
m
.
m
to con rm.
27