Advertisement
8.
The next steps discuss loading and securing the icemaker onto the kit. Please read all the following
steps to determine which mounting method should be utilized. Equally important is to determine if
there is sufficient access in the area of the mounting brackets after the dispenser is lifted onto the
counter. Access should be carefully considered before installation continues because sufficient
room is required for drilling holes, installing screws, etc.
Two options are supplied with this kit for securing the icemaker to the kit. (See Figure 4)
Option 1: Includes two flat brackets. This method may be used if there is sufficient access to the
back of the dispenser in the areas of the mounting brackets.
Option 2: Includes two angle brackets. This method may be used if there is not sufficient access to
the back of the dispenser in the areas of the mounting brackets. Pre-drilling holes should be
considered when using this option.
MOUNTING OPTION 1
(FLAT BRACKETS)
9.
The next step is to secure the icemaker to the kit. Depending on the mounting method chosen, use the
appropriate brackets (supplied) as templates to drill four 9/64" (.140" Dia.) holes into the back side of the
adapter kit. Drill four holes of the same diameter into the icemaker (Figure 4). Ensure the location of the
brackets will not damage the kit or the icemaker prior to drilling any holes. USE EXTREME CAUTION
NOT TO DRILL INTO ANY OTHER COMPONENTS. Drill depths should not go further than the
thickness of the material being drilled (just enough to go through). Secure the two brackets using the
screws provided.
For optimal performance, do not fill ice bin more than 2/3 capacity (maximum fill is 4" below top of
bin). Applies to IDC 255 models only.
© 2005-2010, IMI Cornelius Inc.
IDC Icemaker Adaptor Kit Installation Instructions
MOUNTING OPTION 2
(ANGLE BRACKETS)
FIGURE 4
- 3 -
Publication Number: 629088667INS
Advertisement
