Table of Contents
Advertisement
To switch on intensive mode 2, turn the control ring
2.
clockwise until appears on the display.
a After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
7.5 Switching off intensive mode
Turn the control ring anti-clockwise.
▶
7.6 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
Press
.
▶
a The remaining fan run-on time appears on the dis-
play.
a The fan run-on starts at fan setting 1.
a The appliance switches off automatically after ap-
prox. 10 minutes.
7.7 Setting the run-on time
You can set a run-on time of between 1 and
99 minutes.
To extend the run-on time, turn the control ring
1.
clockwise
To reduce the run-on time, turn the control ring anti-
2.
clockwise.
7.8 Switching off the fan run-on
Press
.
▶
a The appliance starts at the previously selected fan
setting.
7.9 Sensor sensitivity
In automatic mode, a sensor in the appliance detects
the intensity of the cooking and roasting fumes. De-
pending on the setting of the sensor sensitivity, the op-
timum fan setting is automatically switched on. If the
sensor control system reacts too weakly or too
strongly, the setting for the sensor sensitivity may
change.
¡ Factory setting: 6
¡ Lowest setting: 1
¡ Highest setting: 10
7.10 Setting the sensor sensitivity
Requirement: The appliance is switched off.
Press and hold .
1.
a The setting is displayed after approx. one second.
Use the control ring to select the setting.
2.
3.
Release
to save the setting.
7.11 Switching on the lighting
The lighting can be switched on and off independently
of the ventilation system.
Press
.
▶
7.12 Setting the brightness
Press and hold
until the required brightness is
▶
reached.
7.13 Setting the intermediate position for
the filter cover
On some appliances, the filter cover can be adjusted to
an intermediate position. The intermediate position can
be used to eliminate particularly strong cooking smells
and large amounts of steam.
Take hold of the filter cover in the centre and open it
▶
carefully.
7.14 Saturation indicator
If the grease filters or odour filters are saturated, cor-
responding symbols flash after the appliance is
switched off.
Clean the saturated grease filters and, in doing so, ob-
serve the cleaning instructions in these instructions.
Change the saturated odour filters and observe the in-
structions in the accompanying instructions.
If odour filters can be regenerated, follow the instruc-
tions in the accompanying instructions.
7.15 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Requirements
¡ After the appliance has been switched off,
pears in the display for the grease filter.
¡ After the appliance has been switched off,
pears in the display for the odour filter.
To reset the saturation indicator for the grease filter,
1.
press
.
To reset the saturation indicator for the odour filter,
2.
press
.
a The saturation indicator is reset.
7.16 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement: The appliance is switched off.
1.
Press and hold
.
To set circulating-air mode (non-regenerable fil-
‒
ter), use the control ring to change the display to
.
To set circulating-air mode (regenerable filter),
‒
use the control ring to change the display to .
To set air extraction mode, use the control ring to
‒
change the display to .
Release
to save the setting.
2.
Basic operation en
ap-
ap-
7
Advertisement
Table of Contents
