Table of Contents
Advertisement
Problem
"Paint" appears to be
Grease build-up on inside surfaces.
peeling inside lid or hood.
Burner output on "high"
Lack of gas.
setting is too low.
(Rumbling noise and
Supply hose is pinched.
fluttering blue flame at
burner surface.)
Dirty or clogged orifice.
Spider webs or other matter in venturi tube.
ULPG regulator in "low flow" state.
!
If the grill cannot be adjusted to perform correctly, have it inspected by a certified gas installer or the
Napoleon dealer where the product was purchased
N415-0580-AU REV - MAy 11.22
Possible Causes
Solution
This is not a defect. The finish on the lid and
hood is porcelain and will not peel. The
peeling is caused by hardened grease, which
dries into paint-like shards, that flake off.
Regular cleaning will prevent this. See cleaning
instructions.
Check gas level in ULPG cylinder.
Reposition supply hose as necessary.
Clean burner orifice.
Clean out venturi tube.
Ensure lighting procedure is followed carefully.
All gas grill valves must be in the off position
when the tank valve is turned on. Turn tank
on slowly to allow pressure to equalize. See
lighting instructions.
15
www.napoleon.com
Advertisement
Table of Contents
