Miscellaneous - Medisana HKC Instruction Manual

Hide thumbs Also See for HKC:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 13
GB
2 Operating / 3 Miscellaneous
To switch the unit off, move the switch back to position 0. The power LED will go
out, indicating that the unit is switched off. Unplug the unit from the mains outlet.
Move the switch to position 1 for any continuous use. The heat pad will switch
off automatically after approx. 90 minutes of continuous use. To switch it back on
again, move the slider switch to position 0 and then back to the desired heat
setting. Unplug the unit from the mains outlet once you have finished using it.
Additional information for the heat pad for neck and back (Art. 60124 HKN)
This specially-shaped back and neck pad is especially designed for use on these
areas of the body. It is individually adjustable to your body thanks to hook and loop
fasteners in the neck and hip areas.

3 Miscellaneous

3.1 Troubleshooting
This unit is equipped with the active protection system APS TECH. The unit detec-
ts different causes of errors and emits corresponding alarm sounds if necessary. In
the case of an error, the power LED will light up in red.
3 beeps in 1-second interval and power LED lights up in red:
The connection cable of the control unit is not properly connected to the heat pad or
another electrical defect is present. Please check the cable connection. Is the cable
connected properly, please do not use the heat pad and contact the service center.
3 beeps in 2-second interval for one minute and power LED lights up in red:
The heat pad is broken, folded or fully covered. Please use the heat pad only
according to this instruction manual and pay attention to all points in the safety
information chapter.
Constant beeping and power LED lights up in red:
Important components are damaged or there is a short circuit. Please do not use
the heat pad and contact the service center.
If there is no function at all after switching on the heat pad (power LED shows
no light and no beeps can be heard), please check if the mains plug is correctly
plugged in the mains outlet. If this is the case, the heat pad is defect. Please do
not use the heat pad and contact the service center.
14
G
G
G
G
G
G

Advertisement

Table of Contents
loading

This manual is also suitable for:

HksHknHkmHp 6156010460114 ... Show all

Table of Contents