Yamaha R6 2023 Owner's Manual page 35

Display brightness and shift light
control mode
1. Shift light
2. Shift light activation range
3. Brightness level display
This mode cycles through five control
functions, allowing you to make the fol-
lowing settings in the order listed be-
low.
 Display brightness - adjust the
brightness of the displays and ta-
chometer.
 Shift light activity function - set the
shift light to on, flash, or off.
 Shift light activation - set the en-
gine speed at which the shift light
will be come on.
 Shift light deactivation - set the
engine speed at which the shift
light will be go off.
1
 Shift light brightness - adjust the
2
brightness of the shift light.
TIP
Refer to the brightness level display
when adjusting brightness levels.
3
To adjust the display and tachometer
brightness
1. Turn the key to "OFF".
2. Push and hold the "SELECT" but-
ton.
3. Turn the key to "ON", and then re-
lease the "SELECT" button after
five seconds.
4. Push the "RESET" button to set
the brightness level.
5. Push the "SELECT" button to con-
firm the setting. The control mode
changes to the shift light activity
function.
To set the shift light activity function
1. Push the "RESET" button to select
one of the following shift light ac-
tivity settings:
Instrument and control functions
2. Push the "SELECT" button to con-
To set the shift light activation point
TIP
The shift light activation point can be
set between 10000 r/min and 18000
r/min. From 10000 r/min to 13000
r/min, the shift light can be set in incre-
5-14
 On - the shift light will come
on when activated. (This set-
ting is selected when the shift
light stays on.)
 Flash - the shift light will flash
when activated. (This setting
is selected when the shift light
flashes four times per se-
cond.)
 Off - the shift light is deacti-
vated; in other words, it will
not come on or flash. (This
setting is selected when the
shift light flashes once every
two seconds.)
firm the selected shift light activity.
The control mode changes to the
shift light activation point setting
function.
5