Page 1
18” ELECTRIC STAND FAN WITH METAL BLADE PPFS818...
Page 2
Parts & Description LIST OF COMPONENTS Front Grille Main Body screw Back Grille Extension Pole Motor Shaft Height Adjustment Ring Safety Guard Outer Pole Fan Blade (Metal) Base Cover Fan Blade screw Base Main Body (Timer & Speed buttons) Washer Fan Head (containing Motor) L-screw Grille Ring with Grille Ring clip...
Page 3
Fan Blade Fan Head Grille Ring with Grille Ring clip Main Body (Timer & Speed buttons) Main Body screw Extension Pole Height Adjustment Ring Outer Pole Base Cover Base Washer L-screw...
HOW TO ASSEMBLE Warning: DO NOT operate the fan with any of its parts unassembled. The entire assembled unit works as a single appliance. The fan must only operate in the upright position. Any other position will be hazardous. https://youtu.be/tQ5cC_tP7rg Please refer to the video for the correct sequence of steps: 1.
Page 5
5. Insert the Main Body onto the top of the Extension Pole. Secure it by ⑨ ⑪ tightening the Main Body Screw. ⑩ Main Body (Timer & Speed buttons) Main Body screw 6. Assemble the Back Grille and the Fan Blade on the Fan Head as ②...
Page 6
• Insert the Back Grille through the Motor Shaft and secure it to the ② ③ ⑧ Fan Head by screwing the Safety Guard clockwise. ④ • Holding the Fan Blade, loosen the Fan Blade screw anti-clockwise. ⑤ ⑥ Fan Blade screw...
Page 7
• Insert the Fan Blade into the Motor Shaft rear first. ⑤ ③ Motor Shaft groove Fan Blade screw Fan Blade The picture of the left shows the Motor Shaft with the groove easily ③ seen. The picture on the right shows the rear of the ⑤...
Page 8
• Rotate the Fan Blade until the Fan Blade screw is level with the ⑤ ⑥ groove on the Motor Shaft and tighten the Fan Blade screw ③ ⑥ clockwise. • Ensuring the logo at the front of the Front Grille is positioned properly, ①...
Page 9
Warnings ATTENTION : Read this booklet carefully as it contains important instructions for a safe installation, use and maintenance. Important instructions to be kept for future reference. The following basic precautions should always be followed when using electrical appliances: 1. Read all instructions before using the appliance. The Appliance 2.
Page 10
8. Only use original components & accessories provided by the manufacturer. Any non-original component or accessory NOT recommended by the manufacturer (including, but not limited to, Front & Back Grilles, Back Grille screws, Fan Blade, Fan Blade screw, Fan Head, Main Body, Main Body screw, Height Adjustment Ring, Poles, Base, etc.) made by other manufacturers or by the same manufacturer but for other models of the same capacity or otherwise) may cause injuries to persons or damage to the appliance.
Page 11
Operation 16. If you are using the appliance for the first time, you should: a. Clean the exterior parts of the fan thoroughly with warm water & detergent with a non-abrasive sponge and wipe dry. DO NOT use metal scouring pads. Make sure that the Motor Unit DOES NOT come into contact with water.
Page 12
• operate the appliance for more than 6 hours without turning it off for at least 30 minutes to let the appliance cool down for a total usage of 12 hours a day – failure to heed this warning may result in motor failure; •...
Page 13
HOW TO USE 1. Press the ‘0’ Speed Button. 2. Insert the plug directly into the wall socket. Switch the socket switch ON. To turn ON 3. Press the Speed Button to the fan speed (Low – ‘1 / 2 / 3’ – High) you desire. 4.
HOW TO CLEAN 1. Switch the appliance OFF. Wait for the appliance to cool down completely. 2. To disassemble a. Loosen the Grille Ring Clip and detach the Front Grille. b. Holding the Fan Blade, loosen the Fan Blade screw anti-clockwise. c.
DISPOSAL: Do not dispose this appliance as unsorted municipal waste. Collection of such waste separately for special treatment is necessary. SPECIFICATION MODEL PPFS818 FAN DIAMETER 18 inch (46 cm) RATED VOLTAGE 220 – 240 V ~50 – 60 Hz...
3. This warranty does not cover the repair or replacement of part/s damaged by misuse, accidents, negligence, alterations, or modifications in any way, or repairs done by any repair organisation without the prior consent of PowerPac Electrical Pte Ltd. 4. Repair and service are to be performed at: 5 Changi South Lane #03-01 Singapore 486045.
Page 17
In accordance with the terms and conditions of this limited warranty as stated above, PowerPac Electrical Pte Ltd, at its expense shall provide free services for the appliance within the warranty period from its date of purchase from our Authorised...
Need help?
Do you have a question about the PPFS818 and is the answer not in the manual?
Questions and answers