Hallis Hudson AE10 Installation

FaceFix installation

To a Window Frame / Wall
Do not damage the product when using a sharp knife to open
the packaging!Fitting screws: Use a size-2 screwdriver (POZIDRIVE) or use an
electric screwdriver at it's lowest torque .
Rail removal: Use a flat screwdriver of max. 6 mm wide. Only use the original
screws enclosed, to prevent malfunctioning from using too thick screw heads!
FaceFix installation
1

Connection

3
The built-in motor (24 V DC) with automatic end position adjustment
may only be connected to the 230V mains using a stabilized 24 Volt DC
Power Supply. Only use Power Supplies and controls recommended
by the manufacturer of the Pleated Blind, to prevent damage or
malfunctioning caused by non-compatible electric components!
When connecting electric components, the wiring diagram provided by
the manufacturer of the Power Supply must be observed.
Subject to technical changes
Hallis Hudson Group Ltd, Unit B1, Red Scar Business Park, Longridge Road, Preston, Lancashire, PR2 5NJ
Sales Tel: 01772 202 202 | Sales Fax: 01772 515 515 Email: sales@hallishudson.com | www.halliswebshop.com
Installation
2
A
www.hallishudson.com
x

Rail installation sequence on Clips

2-A1 A1
Model
max. 70 cm x
X=5 cm
2-A2 A2

Removal

C
B
A
AE10