Rheem RTGH-95DVELN-3 Use And Care Manual page 34

INSTALLATION INSTRUCTIONS
Vertical Vent Terminal Location
The following chart with diagrams details the minimum dimensional information needed to determine the proper
location of the vertical vent terminal for direct-vent indoor tankless water heaters:
Location
A = Minimum clearance above the roof
level.
B = Maximum clearance above roof
level (without additional support for
vent pipe).
C = Required vent clearance from any
gable, dormer, or other roof struc-
ture with building interior access
(i.e., vent, window).
D = Required vent clearance from any
forced air inlet, including dryer and
furnace air inlets.
E = Minimum/maximum horizontal dis-
tance between vent terminals
1 In accordance with current ANSI Z223.1/NFPA 54 National Fuel Gas Code.
2 In accordance with current CAN/CSA B149.1 Installation Codes.
The vertical intake air termination requires a return
bend or two short or long sweep radius 90° elbows
to keep the inlet downward and prevent entry of rain.
Refer to figure above for the proper location of the air
intake with respect to the exhaust outlet termination.
34
Optional
12" Min.
Air Intake
(300 mm)
A, B
U.S. Installation Requirements
12 in. (30 cm) above roof level.
24 in. (61 cm) above roof level.
4 ft. (1.2 m)
10 ft. (3 m)
5.5 in. (14 cm)/24 in. (61 cm)
Vent Pipe
Through Roof
Canadian Installation Requirements
1
18 in. (45.7 cm) above roof level.
24 in. (61 cm) above roof level.
4 ft. (1.2 m)
6 ft. (1.8 m)
5.5 in. (14 cm)/24 in. (61 cm)
The vertical exhaust outlet termination is a 2-inch or
3-inch pipe which terminates at least 12 inches (30
cm) above the air intake termination. The exhaust
outlet terminations must be at least 12 inches (30
cm) in US [at least 18 inches (46 cm) in Canada]
above the roof line or anticipated snow levels.
2