Table of Contents
Advertisement
Service
Belt Replacement
To remove and replace either the auger belt or the drive
belt, follow the steps below and then proceed to the
specific steps listed under respective sub-headings.
1.
Disconnect the chute crank assembly by removing the
two nuts which secure the chute bracket to the chute
adapter. See Figure 7-1.
Nuts &
Washers
2.
Remove the plastic belt cover, located near the engine,
by removing the three self-tapping screws that secure
it. See Figure 7-2.
18
Figure 7-1
Figure 7-2
3.
a.
Loosen the bolt shown in Figure 7-3 securing
the belt keeper bracket and remove the other
bolt.
b.
Push the belt keeper and bracket up off the
engine pulley. See Figure 7-3.
Loosen
Figure 7-3
Auger Belt Replacement
1.
Remove the clip and flat washer from the ferrule in
order to disconnect the auger idler rod from the brake
bracket assembly. See Figure 7-4.
2.
Slip the auger belt (the front belt) off the engine pulley.
Figure 7-4
7
Remove
Hairpin Clip
and Washer
Ferrule
Auger Idler Rod
Advertisement
Table of Contents
