Gardena 1874 Operating Instructions Manual page 9

Activate / deactivate
watering programme :
[Level 6]
3.
4.
5.
The Prog ON must be selected so that the watering programme
OFF
can start. With Prog
ON OFF
Prog / can be independently selected for each valve.
OFF
Also with Prog manual watering is possible.
ï
1. Select Valve 1 (
▼-▲ button (V1 / V2) (if a programme was previously created
then the valve cannot be selected, the corresponding valve is
automatically selected).
2. Press Menu button 5 times [Level 6] (not necessary if a
programme was previously created).
3. Select Prog ON or Prog
confirm with the OK button.
OK
For 2 sec. Prog
the Normal Display [Level 1] .
Prog ON : The water computer has now been programmed, i.e. the
inbuilt valve opens and closes completely automatically and thus
waters at the programmed time.
B) Direct sensor control
Prerequisite : at least one GARDENA Soil Moisture Sensor is
connected (see 4. Initial Operation). Watering nights (20:00 –
06:00), if the sensor registers dry.
A previously set scheduled watering programme is stored but
not carried out.
1. Select programme for Valve 1 (
with the ▼-▲ buttons (V1/ V2).
2. Press Menu button 3 times.
Run Time and the watering duration flash on the display.
3. Set watering duration hours with the ▼-▲ buttons (e.g.
0
hours) and confirm with the OK button.
Run Time and the watering duration minutes flash on
the display.
4. Set watering duration minutes with the ▼-▲ buttons (e.g.
10
minutes) and confirm with the OK button.
Watering cycle flashes on the display.
5. Select direct sensor control
confirm with the OK button.
After each watering, a 2-hour watering pause is triggered in
order for the Soil Moisture Sensor to record the soil moisture.
automatic watering is deactivated.
ð
V1) or Valve 2 (V2
with the ▼-▲ buttons and
OFF
is shown and then the display moves to
:
ï
V1) or Valve 2 (V2
with the ▼-▲ buttons and
) with the
ð
)
9