Cisco Catalyst Wireless 9166D1 Hardware Installation Manual page 10

Cisco Catalyst Wireless 9166D1 Wi-Fi 6E Access Point Features
• A 4x4:4 2.4-GHz radio
• A tri-band scanning radio for Cisco CleanAir Pro
• A 2.4-GHz IoT (BLE) radio
• Environmental Sensors:
• Ambient temperature sensor
• Air quality sensor (Total Volatile Organic Compound [TVOC])
• Relative humidity sensor
• Accelerometer
Note The environment sensors are configurable on Cisco Spaces platform.
For more information on how to configure the AP sensor in Cisco Spaces, see
the
• Integrated internal antennas are directional for the 2.4-GHz, 5-GHz, and 6-GHz bands.
• Scanning radio uses two 2.4-GHz, 5-GHz, and 6-GHz antennas.
• Multiuser Multiple-Input Multiple-Output (MU-MIMO) technology for uplink and downlink.
• Orthogonal Frequency Division Multiple Access-based (OFDMA-based) scheduling for both uplink and
downlink.
• The following hardware external interfaces:
• 1x100/1000/2500/5000 Multigigabit Ethernet (RJ-45)
• RS-232 Console Interface through RJ-45
Note The console port default baud rate is 115200.
• Recovery push button (enables partial or full system configuration recovery)
• USB 2.0 port, type-A connector
• DC 54V power jack
• One multicolor LED
• Integrated Bluetooth Low Energy (BLE) radio to enable IoT use cases such as location tracking and
wayfinding.
• Intelligent Capture probes the wireless network and provides Cisco DNA Center with deep analysis.
• Spatial Reuse (also known as Basic Service Set [BSS] coloring) that allows APs and their clients to
differentiate between multiple BSS, thus permitting more simultaneous transmissions.
Cisco Catalyst Wireless 9166D1 Wi-Fi 6E Access Point Hardware Installation Guide
2
AP as a Sensor section in the Cisco Spaces: IoT Services Configuration Guide.
About the Access Point