Chapter 1 - Basic Operation; Choosing A Location; Connecting Power - First Alert Public Alert WX-268 User Manual

Chapter 1 - Basic Operation

Setting up your Public Alert
1. Choosing a place for your radio
Your WX-268 is designed for desktop or wall mount installation. Place the unit where it
can receive an emergency alert signal broadcast and where you can hear its alert tone or
see the message indicator lights. The best location to install the WX-268 is:
- Clear of any obstructions.
- Near windows or large openings.
- Near an AC power outlet
- Near to where the user(s) would normally stay, such as a bedroom, living room or
office.
• Adjust LCD flip door for best viewing angle.
• Keep the receiver away from interference sources e.g. motors, computers, TV or
microwave ovens.
The WX-268 has 4 separate antennas.
Weather Band - 21" Telescopic antenna. Fully extend antenna. Adjust by moving.
FM - The FM antenna is in the power cord. Straighten for best reception. To receive FM
signal make sure power cord is connected to the radio.
AM and Auto-set Clock - These antennas are internal ferrite bar antennas.
is being used on a desk or table top, try rotating it 90 degrees to improve reception. If
your radio is mounted to the wall, try mounting it on a wall perpendicular to the one it
is currently on (e.g. if it is on a north-south wall try an east-west wall).
2. Connecting the Power
USING A STANDARD 120V AC
OUTLET
1. Plug the AC adapter cord into the 9V
AC input jack on the back of the unit.
2. Plug the adapter into the wall outlet.
Note: The internal battery charger will automatically begin to charge the
batteries if the "Rechargeable" setting is selected. Keep the unit plugged
in at all times. The unit will be ready to use in the event of a power failure.
VEHICLE USE (12V DC)
Use an optional 12V DC car adapter (not included). Plug the adapter cord into
the 12V DC input jack on the back of the unit. Plug the other end into your
vehicle's cigarette lighter or accessory outlet.
radio
TM
If your radio
11