Related Manuals for Electrolux EFI 630
Summary of Contents for Electrolux EFI 630
- Page 1 INSTRUCTION BOOK FOR ELECTROLUX COOKER HOOD EFI 625 and EFI 630 cod. 4329618 04 - 010911 Get other manuals https://www.bkmanuals.com...
- Page 2 If you require guidance in the use of the appliance or require further information on Electrolux Products, please contact our Customer Care Department. For general enquiries concerning your Electrolux appliance or for further information, visit our website at http:\\www.electrolux.co.uk...
-
Page 3: Important Safety Information
It is dangerous to alter the specifications or modify inexperienced persons may cause injury or more this product in any way. serious malfunction. Refer to your local Electrolux Service Force Centre. Always insist on genuine spare • When installed between adjoining wall cabinets the parts. -
Page 4: Your Appliance
YOUR APPLIANCE OPERATING INSTRUCTIONS This cooker hood is designed to extract unpleasant odours from the kitchen, it will not extract steam. To obtain the best performance it is advisable to switch on the hood a few minutes before you start cooking and leave it running for approximately 15 minutes after finishing. -
Page 5: Extraction Mode
To Operate Open the visor and select the required functions. The appliance can be installed to recirculate or extract contaminated air. The cooker hood is more effective when used in the extraction mode. Recirculation The hood is supplied specified for use in the recirculation mode with the charcoal filter/s fitted. -
Page 6: Maintenance And Cleaning
MAINTENANCE AND CLEANING Before carrying out any maintenance or cleaning isolate the cooker hood from the mains supply. The cooker hood must be kept clean, as a build up of grease or fat can be a fire hazard. External Cleaning Wipe the cooker hood frequently with warm soapy water using a mild detergent. -
Page 7: Changing The Lamps
Clean the metal inlet grille/s and motor support/ s before replacing the charcoal filter/s. Place the new charcoal filter/s (B) over the motor support/s (A), and while holding the filter securely insert the disk (C) and turn clockwise. This appliance can be a fire hazard if the grease and charcoal filters are not replaced as recommended. -
Page 8: Something Not Working
If you require an engineer or wish to purchase spare For general assistance with your appliance or for parts contact your local Service Force Centre by information on Electrolux products please contact our telephoning: Customer Care Department. Customer Care Department,... -
Page 9: Guarantee Conditions
STANDARD GUARANTEE CONDITIONS We, Electrolux, undertake that if within twelve months of the date of the purchase this Electrolux built-in appliance or any part there of is proved to be defective by reason only of faulty workmanship or materials, the company will, at our option repair or replace the same FREE OF ANY CHARGE for labour, materials or carriage on condition that: •... -
Page 10: Installation Instructions
598mm DEPTH: 270-360mm DEPTH WITH VISOR OPEN: 540-630mm WEIGHT GROSS: EFI 625 12,5 kg - EFI 630 14 kg NET: EFI 625 10,9 kg - EFI 630 12,5 kg ELECTRICAL SUPPLY: Voltage (~50Hz) 220-240 V POWER CONSUMPTION: EFI 625 190 W - EFI 630 225 W... -
Page 11: Installing The Cooker Hood
(not supplied). Ducting The ducting must be fire retardant (EFI 625) 100mm (4ins), and (EFI 630) 125mm (5ins) in diameter and the length should be no more than: 3 metres with one 90° bend 2 metres with two 90° bends Bends of more than 90°... -
Page 12: Fitting The Wall Brackets
Clearance Height A minimum clearance height of 650mm (25 1/2 ”) is required when installed above a built-in electric hob, or 700mm (27 1/2 ”) when installed above a built-in gas hob. A minimum clearance height of 685mm (27”) is required when installed above a slot-in electric cooker, or 787mm (30 1/2 ”) when installed above a slot-in gas cooker. - Page 13 EFI 625 - Connect the 100mm (4 ins) ducting to the spigot and make an air tight seal. EFI 630 - Fit the 120 to 125mm flange to the spigot, then connect the 125mm (5 ins) ducting to the spigot and make an air tight seal.
- Page 14 Fitting the Cooker Hood to the Wall Fit the brackets with the round ends facing downwards using the plastic rawl plugs and screws provided. Once the brackets are secured, lift the hood squarely to the wall slightly higher than the brackets and lower the cooker hood until it is located onto the two brackets.
- Page 15 To Refit the Hood with Decor Panel Attached Insert the upper visor guides into the upper track in the front of the casing. Pull down the bottom edge of the visor and insert the lower guides into the track in the bottom of the casing.
- Page 16 Get other manuals https://www.bkmanuals.com...
- Page 17 Get other manuals https://www.bkmanuals.com...
- Page 18 Get other manuals https://www.bkmanuals.com...
- Page 19 Get other manuals https://www.bkmanuals.com...
- Page 20 55 - 77 High Street - Slough BERKSHIRE SL1 1DZ © Electrolux Household Appliances Limited 2001 Get other manuals https://www.bkmanuals.com...