Table of Contents
Advertisement
WARNING: CO
CO
(carbon dioxide) gas leaks in the entire CO
2
suspected, particularly in a small area, immediately ventilate the contaminated area before
attempting to repair the leak. Personnel exposed to high concentration of CO
tremors which are followed rapidly by loss of consciousness and suffocation.
1. Fully close (clockwise) CO
2. Slowly loosen CO
regulator assembly coupling nut allowing CO
2
tor assembly from empty CO
3. Unfasten safety chain and remove empty CO
WARNING: To avoid personal injury and/or property damage, always secure CO
in an upright position with safety chain to prevent it from falling over. Should the shutoff
valve become accidentally broken off, CO
4. Position CO
cylinder and secure with safety chain.
2
5. Make sure gasket is in place inside CO
6. Open (counterclockwise) CO
fully to back-seat valve. (Back-seating valve prevents leakage around valve shaft).
7. Check CO
connections for leaks.
2
REPLENISHING BEER SUPPLY
(see Figure 2)
1. Close CO
and beer line shutoff valves for the empty beer keg.
2
2. Remove beer keg tapper from the empty beer keg.
3. Make sure beer keg tapper and top of the full beer keg are clean, then then install tapper in the keg.
4. Open CO
and beer line shutoff valves.
2
569000246
displaces oxygen. Strict attention must be observed in the prevention of
2
cylinder valve.
2
cylinder.
2
2
regulator coupling nut, then install regulator on CO
2
cylinder valve slightly to allow lines to slowly fill with gas, then open valve
2
183296-000
*Quad ring seal must be replaced each
time check valve is serviced.
FIGURE 7. CO
and soft drink system. If a CO
2
pressure to escape, then remove regula-
2
cylinder.
cylinder can cause serious personal injury.
2
QUAD RING
183294-000
BALL
SPRING
183297000
RETAINER
183298000
BODY
183295000
GAS CHECK VALVE
2
22
gas leak is
2
gas will experience
2
cylinder
2
cylinder.
2
Advertisement
Table of Contents
