Table of Contents
Related Manuals for Cornelius FCB Pinnacle 2 Flavor
Summary of Contents for Cornelius FCB Pinnacle 2 Flavor
- Page 1 INSTALLATION MANUAL FCB Pinnacle 2 and 4 Flavor Release Date: November 17, 2005 Publication Number: 560007295INS Revision Date: March 24, 2014 Revision: G Visit the Cornelius web site at www.cornelius.com for all your Literature needs...
-
Page 2: Contact Information
Commercial Warranty. Cornelius will not be responsible for any repair, replacement or other service required by or loss or damage resulting from any of the following occurrences, including but not limited to, (1) other than normal and proper use and normal... -
Page 3: Safety Instructions
Failure to comply could result in serious injury, death or damage to the equipment. CAUTION: Always be sure to keep area around the unit clean and free of clutter. Failure to keep this area clean may result in injury or equipment damage. © 2003-2014, Cornelius Inc. - 1 - Publication Number: 560007295INS... -
Page 4: Installation Instructions
209 to 240 VAC Use line voltage. 241 to 253 VAC Reduce voltage by -16 V. 254 to 272 VAC Reduce voltage by -32 V. Above 272 VAC DO NOT connect unit. Publication Number: 560007295INS - 2 - © 2003-2014, Cornelius Inc. -
Page 5: Environmental Requirements
2. Remove packing fillers from top of the unit. 3. Open the packages of loose parts and inspect all of the parts. The Magnet Puller Tool is P/N 560003662 (stored at the inside base of the frame). © 2003-2014, Cornelius Inc. - 3 - Publication Number: 560007295INS... -
Page 6: Initial Installation
3. Feed the power cord through the strain relief either through the bottom or back of the frame, see Figure 2. and into the power box. 2. Into the Bottom of the Power Box 1. Through the Frame Strain Relief Figure 2. Publication Number: 560007295INS - 4 - © 2003-2014, Cornelius Inc. - Page 7 , and Water Sold Out errors exist. Press ERR to see the complete list of errors. 4. If these errors DO NOT appear, troubleshooting the Sold Out System is required. Continue if the errors are present. © 2003-2014, Cornelius Inc. - 5 - Publication Number: 560007295INS...
- Page 8 22 – 28 psi (the regulator is factory set to 23 psi). Open the Freeze Cylinder Shutoff Valves (see Figure 5.), valve lever parallel to valve body (open position). The CO error on the display will automatically reset itself. Publication Number: 560007295INS - 6 - © 2003-2014, Cornelius Inc.
- Page 9 3. Remove the top cover and open the water bath fill valve (Figure 6.) and fill the water bath just to the top of the product cooling coils (Figure 7.) © 2003-2014, Cornelius Inc. - 7 - Publication Number: 560007295INS...
- Page 10 5. Turn on the Blendonators by going into menu 14 and turning both to ON. 6. The product delivery pumps will now turn on and fill the Blendonator tanks. Continue by Brixing the unit. Publication Number: 560007295INS - 8 - © 2003-2014, Cornelius Inc.
-
Page 11: Adjust Water-To-Syrup Ratio (Brix)
7. If reading is out of specification the syrup level needs to be adjusted. Never change the Water Flow Control setting to adjust Brix (Figure 10.) Syrup Flow Control Water Flow Control Figure 10. © 2003-2014, Cornelius Inc. - 9 - Publication Number: 560007295INS... -
Page 12: Starting Unit
6.3 to 6.9 oz. (186 to 204 ml) in 3 seconds. Setting Up Control Panel Refer to the Control Panel section in the Pinnacle Service Manual on www.cornelius.com for detailed explanation of the following procedures. •... - Page 13 2. Attach the Over Flow Drain Tube to the Frame and Drip Tray Extension Bracket, as shown, with the two (2) 3/8” nylon clamps and two (2) 1/2” 8-32 screws. Cable Tie with Eyelet Over Flow Drain Tube Screws Fixed Diameter Clamp Mounted to Extension Bracket Figure 12. © 2003-2014, Cornelius Inc. - 11 - Publication Number: 560007295INS...
- Page 14 5. Add the 2 Spacers to the rear side of the Splash Panel before attaching it to the Frame. Spacers on Rear of Splash Panel Figure 14. 6. Secure the Splash Panel to the Frame using four (4) 1-1/4” 8-32 screws. Figure 15. Publication Number: 560007295INS - 12 - © 2003-2014, Cornelius Inc.
-
Page 15: Cart Mount
4. Add the 2 Spacers to the rear side of the Splash Panel before attaching it to the frame (Figure 14.) 5. Secure the Splash Panel to the Frame using four (4) 1-1/4” 8-32 screws. Figure 18. © 2003-2014, Cornelius Inc. - 13 - Publication Number: 560007295INS... -
Page 16: Appendix A - Remote Condenser
C. Never wire condenser into Pinnacle section. The condenser is an independent electrical connection. D. Fan motor will not start until pressure rises to 275 PSIG closing the fan cycling switch. Publication Number: 560007295INS - 14 - © 2003-2014, Cornelius Inc. -
Page 17: Making Connections
Bending the lines should be done carefully to prevent kinks. Coil excess line should be indoors if possible. Minimize the number of coils, and lay the coils horizontally if possible. NOTE: Installing an Cornelius remote Pinnacle with a remote condenser and line set other than an Cornelius may void the Pinnacle warranty. -
Page 18: Appendix B - Historic Brix Procedures
1. Make sure the status of all cylinders is OFF. 2. Press MENU, press UP until BRIX is selected, press GO, select cylinder to be BRIXed. NOTE: Pressing CANCEL will stop the process. Publication Number: 560007295INS - 16 - © 2003-2014, Cornelius Inc. - Page 19 9. Repeat procedure for additional freeze cylinders. 10. Turn the freeze cylinder shutoff valves to the ON position. Press MENU, press UP until blendonator is selected, press GO, select the desired cylinder, press ON. © 2003-2014, Cornelius Inc. - 17 - Publication Number: 560007295INS...
- Page 20 CYLINDER VALVE WATER FLOW REGULATOR AND SOLENOID VALVE PRODUCT SHUTOFF VALVE CHECK VALVE SYRUP PRODUCT PUMP (SYRUP AND WATER ARE MIXED) BLENDONATOR WATER ICE BATH PRODUCT SAMPLE VALVE Figure 28. Publication Number: 560007295INS - 18 - © 2003-2014, Cornelius Inc.
- Page 21 14. Repeat steps 11-13 until the product BRIX is within specification. 15. Repeat steps 8-14 until Blendonator #2 product BRIX is within specification. 16. Scroll to the BLENDONATOR menu and turn both Blendonators ON. © 2003-2014, Cornelius Inc. - 19 - Publication Number: 560007295INS...
- Page 22 FCB Pinnacle 2 and 4 Flavor Installation Manual Publication Number: 560007295INS - 20 - © 2003-2014, Cornelius Inc.
- Page 24 Cornelius Inc. www.cornelius.com...