Operation - Krell Industries KMA-i800 Owner's Reference Manual

KMA-i800 Owner's Reference

Operation

Power
Connect the KMA-i800 to an AC mains outlet and turn on the rear panel power switch. After about 4 seconds the front
panel indicator lights will illuminate green. The unit is now in stand-by. Wait another 8 seconds then press and release the
power button. An audible click will be heard from the unit and the indicator lights will fade from green to blue. The blue
illumination will fade out and in for about 8 seconds and then remain constant. The KMA-i800 is now ready to play. To
return to stand-by press the power button again.
Web Interface
The KMA-i800 has a Web interface that provides status information and the ability to remotely control the unit. It is easily
accessed with most commonly available Web browsers. First, with the unit off, connect an Ethernet cable from the rear
panel jack on the KMA-i800 to the LAN router. Turn on the rear panel power switch. Open a Web browser on a device
connected to the same LAN and type http://krell-kmai800-xxxx.local into the URL window (xxxx is the last four digits of
the serial number).
When the KMA-i800 is in stand-by the Web page will be grayed-out and only the Power button will be active. Click on the
Power button to turn on the unit. The KMA-i800 will turn on and a few seconds later the Web page will come up to full
brightness and various status information will be displayed.
About 15 seconds later the temperature display will appear. Channel 1 is the right side and Channel 2 is the left side.
During use it is normal for there to be a difference of a few degrees between the sides.
The No Signal Timeout feature will put the KMA-i800 in stand-by if an input signal is not detected during the selected time
period. The default setting is Disabled.
© 2023 by Krell Industries LLC. All rights reserved. Page 8 of 15