Connection With The Mains; Operation; Stand-Alone Mode; Control Board - EuroLite LED THA-60PC User Manual

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the device to the mains, the LED THA-60PC Theater Spot starts running.
The display lights up and you can choose the desired mode via the buttons MODE, ENTER, UP, DOWN.
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.

Stand-alone mode

In the stand-alone mode, you can do without a controller.
Disconnect the EUROLITE LED THA-60PC Theater Spot from the controller.

Control Board

The Control Board offers several features: you can easily set the starting address or adjust the brightness.
Enter the menu by pressing the MODE-button. Browse through the menu by pressing UP or DOWN. Press
ENTER in order to select the desired menu. You can change the selection by pressing UP or DOWN. Press
ENTER in order to confirm. You can leave every mode by pressing MODE. The functions provided are
described in the following sections.
International
L
N
25/32 00095814, Version 1.0