Download Print this page

Banner K50RPLPGRYC3QPMA Manual

Advertisement

Quick Links

EZ-LIGHT K50 and K80 Specialty — 3-Color
Compact, single-point devices for error-proofing of bin-picking operations
For the latest technical information about this product, including specifications, dimensions, and wiring, see
Models
Model
K50RPLPGRYC3QPMA
K50RPLPGRYC4QPMA
K50APFF50GRYC3QPMA
K50APFF50GRYC4QPMA
K50APFF100GRYC3QPMA
K50APFF100GRYC4QPMA
K50APPBGRYC3QPMA
K50APPBGRYC4QPMA
K80APPBGRYC3QPMA
K80APPBGRYC4QPMA
* 5-pin 150 mm Euro-style PUR pigtail QD models are listed. For 2 m (6') PVC cable model, omit suffix "QPMA" from model number (e.g.,
"K50RPLPGRYC3"). For 9 m (30') PVC cable model, replace suffix "QPMA" with "W/30" (e.g., "K50RPLPGRYC3 W/30"). For 150 mm
(6") PVC pigtail with 5-pin Euro-style fitting, replace suffix "QPMA" with "QP" (e.g., "K50RPLPGRYC3QP").
A model with a QD requires a mating cable (see
** PNP models only are listed. For other output types, contact the Factory.
WARNING: Not To Be Used for Personnel Protection
Never use this product as a sensing device for personnel protection. Doing so could lead to serious injury
or death. This product does NOT include the self-checking redundant circuitry necessary to allow its use in
personnel safety applications. A sensor failure or malfunction can cause either an energized or de-ener-
gized sensor output condition.
P/N 137551 rev. A
• Rugged, cost-effective and easy-to-install solutions for error-proofing and
parts-verification applications
• Compact devices are completely self-contained — no controller needed
• Illuminated dome provides a big, easy-to-see green, red or yellow job light
• Push-button and passive-actuation models available
• Choose NPN or PNP output, depending on model
• Fully encapsulated IP67 construction — ideal for use in abusive environ-
ments; rated to IP69K, depending on installation; see specifications
• Immune to ambient light, EMI and RFI interference
• 12 to 30V dc operation
Sensing Mode /
Housing
LED
Polarized retrore-
flective, visible red,
680 nm
50 mm dome
30 mm mount
Fixed field, infra-
polycarbonate
red, 880 nm
Push button
50 mm dome
Flat or DIN- mount
polycarbonate
5-Pin Euro-Style Cordsets
7/7/2011
Range
Cable*
2 m
50 mm cutoff
5-pin Euro
100 mm cut-
PUR pigtail
off
QD
on page 4).
www.BannerEngineering.com
Output***
Job Light
PNP,
normally
closed
Green/
yellow/
red
PNP,
normally
open
0 137551
8

Advertisement

loading

Summary of Contents for Banner K50RPLPGRYC3QPMA

  • Page 1 • Immune to ambient light, EMI and RFI interference • 12 to 30V dc operation Models Sensing Mode / Model Housing Range Cable* Output*** Job Light K50RPLPGRYC3QPMA Polarized retrore- PNP, flective, visible red, normally K50RPLPGRYC4QPMA 680 nm closed K50APFF50GRYC3QPMA 50 mm cutoff...
  • Page 2 EZ-LIGHT K50 and K80 Specialty — 3-Color Overview The solid-state output interfaces to a system controller, which is pre-programmed for a specific sequence of tasks. Mounted in or near each bin in an assembler’s work station, the sensor job light signals the assembler: •...
  • Page 3: Specifications

    EZ-LIGHT K50 and K80 Specialty — 3-Color Specifications Supply Voltage and Current Job Light Enable 12 to 30V dc (10% max. ripple) Input impedance: 8K Ohms Less than 90 mA max. current @ 12V dc (exclusive of Sinking – Input low < 1.0V load) Sourcing –...
  • Page 4 EZ-LIGHT K50 and K80 Specialty — 3-Color Dimensions K50L K80L 80.8 mm 3.18" 65.0 mm 7.9 mm 2.56" 0.31" Ø15.6 mm (Ø0.61") 50.0 mm 65.0 mm (1.97") 2.56" 36.8 mm (1.45")* 7.6 mm 0.30" M30x1 Ø50.0 mm 20.0 mm (0.79") (mounting nut included) 1.97"...
  • Page 5: Mounting Brackets

    EZ-LIGHT K50 and K80 Specialty — 3-Color Mounting Brackets All measurements in mm SMB30A SMB30SC • Right-angle bracket with • Swivel bracket with 30 mm curved slot for versatile ori- mounting hole entation • Black reinforced thermoplas- • Clearance for M6 (¼") hard- tic polyester ware •...
  • Page 6 EZ-LIGHT K50 and K80 Specialty — 3-Color Retroreflective Targets NOTE: For a complete selection of retroreflective targets, see www.BannerEngineering.com. BRT-2X2 BRT-35X35B • Square, acrylic target • Square, acrylic target • Reflectivity factor: 1.0 • Reflectivity Factor: 1.3 • Max. temperature: 50° C •...
  • Page 7 EZ-LIGHT K50 and K80 Specialty — 3-Color Retroreflective Tape NOTE: For maximum adhesion of all tape products, surfaces must be clean. Model Reflectivity Factor Maximum Temperature Size Unit BRT-THG-1-100 60°C (140°F) 25 mm (1") wide 2.5 m (100") long BRT-THG-2-100 60°C (140°F) 50 mm (2") wide 2.5 m (100") long...
  • Page 8 Banner Engineering Japan Cent-Urban Building 305 3-23-15, Nishi-Nakajima Yodogawa-Ku, Osaka 532-0011 JAPAN, Tel: 81-6-6309-0411, Fax: 81-6-6309-0416, www.bannerengineering.co.jp, mail@bannerengineering.co.jp Banner Engineering Int’l Incorporated Taiwan Rep. Office 8F-2, No. 308, Sec. 1, Neihu Rd. Taipei, Taiwan 114 Phone: +886 2 8751 9966 #15 | Fax: +886 2 8751 2966, www.bannerengineering.com.tw, info@bannerengineering.com.tw Banner Engineering India Pune Head Quarters Office, No.

This manual is also suitable for:

K50rplpgryc4qpmaK50apff50gryc3qpmaK50apff50gryc4qpmaK50apff100gryc3qpmaK50apff100gryc4qpmaK50appbgryc3qpma ... Show all