Sherwood NewCastle R-965 Upgrade Manual page 4

14. If you receive the message below it means the upgrade failed. In this case, just power the receiver off
and then on rapidly (within 1 second) for a reset. After the reset, click "OK" on the ERROR message and then click
the "Upgrade" button, again.
Note : The 'Device Restart' message means something is wrong or failed in the above procedure. In case of
this message, check your cable or COM port. If the connection is good, turn the Newcastle unit off and then on
again and re-try the upgrade procedure from step 13
15. 'Program Success!' message means the update is complete.
16. Exit the update program.
17. Power off the receiver and set OPR/SVC switch on the rear panel to the OPR position.
above.