Table of Contents
Related Manuals for Neilsen CT1084
Summary of Contents for Neilsen CT1084
- Page 1 1/4” AIR DIE GRINDER CT1084 ORIGINAL INSTRUCTIONS Cannon Tools Limited Address: 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. SAVE THESE INSTRUCTIONS AND PRECAUTIONS. READ ALL PRECAUTONS AND INSTRUCTIONS BEFORE USE.
-
Page 2: Ec Declaration Of Conformity
In case of alteration of the machine, not agreed upon by us, this declaration will lose its validity. Product description: 1/4” AIR DIE GRINDER Model: CT1084 Applicable EC Directives: EC Machinery Directive 2006/42/EC Harmonized standards EN ISO 11148-6 20 Station Road, Rowley Regis, West Midlands, B65 0JU.U.K. -
Page 3: Product Specifications
PRODUCT SPECIFICATIONS Free speed 22000/min Max. operating pressure 0.65MPa Avg. air consumption 5cfm Hose Size 3/8” Air inlet 1/4” Net weight(without accessories) 0.66kg SAVE THIS MANUAL You will need this manual for the safety warnings and precautions, assembly, operating, inspection, maintenance and cleaning procedures, parts list and assembly diagram. - Page 4 tired or under the influence of drugs, alcohol, or medication. A moment of inattention while operating pneumatic tools may result in serious personal injury. 2. Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep your hair, clothing, and gloves away from moving parts.
-
Page 5: Specific Safety Rules
accidentally. 5. Store idle tools out of reach of children and other untrained persons. Tools are dangerous in the hands of untrained users. 6. Maintain tools with care. Do not use a damaged tool. Tag damaged tools “Do not use” until repaired. 7. - Page 6 fitting of the Die Grinder. 5. Always disconnect the Die Grinder from its compressed air supply source, and squeeze the Trigger to release all compressed air in the tool before performing any maintenance or services. 6. Industrial applications must follow OSHA requirements. 7.
- Page 7 To Operate The Die Grinder: 1. WARNING! Always wear ANSI approved safety glasses, a full face shield, and hearing protection when operating the Die Grinder. 2. Use the two Spanners provided to loosen the Collet Nut. (See Figure B, next page.) 3.
- Page 8 5. Connect the air supply hose to the Quick Connector on the Die Grinder. Turn on the air compressor, and set its regulator to the recommended 90 PSI for the Die Grinder. (See Figure A.) 6. In order to keep the air supply hose out of the way, hang it over your shoulder.
-
Page 9: Inspection, Maintenance, And Cleaning
Trigger from accidentally being activated. (See Figure C.) 11. Turn off the air compressor. Trip the Safety with your finger, and slowly squeeze the Trigger to release any remaining air pressure from the Die Grinder. Then, disconnect the air hose from the tool. (See Figure A.) 12. -
Page 10: Assembly Diagram And Parts List
THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO. - Page 12 CANNON TOOLS LTD Add: 20 station road, Rowley Regis, west midlands,B65 0JU.U.K. Made in China...