Table of Contents
Advertisement
Correcting keystone
Keystoning refers to the situation where the projected image is noticeably wider at either the
top or bottom. It occurs when the projector is not perpendicular to the screen.
To correct this, you will need to manually correct it following ONE of these steps.
•
Using the remote control
Press
/
on the projector or remote control
to display the Keystone correction page. Press
correct keystoning at the top of the image. Press
to correct keystoning at the bottom of the image.
•
Using the OSD menu
1.
Press MENU/EXIT and then press
2.
Press
to highlight Keystone and press MODE/ENTER. The Keystone correction
page displays.
3.
Press
to correct keystoning at the top of the image. Press
keystoning at the bottom of the image.
to
Press
/
until the DISPLAY menu is highlighted.
/ .
Press
/
.
to correct
Operation
19
Advertisement
Table of Contents
