Table of Contents
Advertisement
Oil Level
Maintain the oil level between the safe
marks on the dipstick.
Oil Change
Change the oil after the initial 20 hours of
operation and again after each 50 hours.
Cleaning Your Snowmobile
Keeping your snowmobile clean will not only improve its appearance but it can also
extend the life of various components. With a few precautions, your sled can be
cleaned much like an automobile.
Washing
If a high pressure type car wash system is used, extreme care must be taken to
avoid water damage to the hood, console, nosepan, decals, and warning labels.
Many expensive repair bills can result from using high pressure detergent sys-
tems.
NOTE: If a high pressure car wash is used, grease all zerk fittings immediately af-
ter washing. Also run the vehicle to evaporate any water that might have entered
the engine or exhaust system.
The best and safest way to clean your sled is with a garden hose and a pail of mild
soap and water. Use a professional type washing mitten, cleaning the upper body
first and the lower parts last. Rinse with water frequently and dry with a chamois
to prevent water spots. NOTE: If warning labels are damaged, contact your a Po-
laris dealer for free replacement.
Waxing
Your snowmobile can be waxed with any high quality brand of automotive paste
wax. Avoid the use of harsh cleaners since they can scratch the body finish.
Controls and Linkage
All bushings, spindle shafts, and tie rod ends should be coated with a light coat of
oil or grease. Throttle and brake controls and cables should be lubricated with
LPS1, WD-40, etc. Force a small amount of lubricant down the cable.
Bearings
To prevent corrosion which will destroy the bearings, always grease drive shaft
clutch side bearings with a high quality bearing grease.
Electrical Connections
Separate electrical connector blocks and clean corrosive build up from connec-
tors. Lubricate or pack connector blocks with Nyogelt grease (PN 2871329) and
re-connect. Replace worn or frayed electrical wire and connectors. Be sure wiring
harness is properly secured away from sharp edges, steering linkage, moving
parts, and hot exhaust.
MAINTENANCE
Safe Oil Level
Between Marks
A--43
Advertisement
Table of Contents
