Abbott FreeStyle Libre 14 day Quick Start Manual

FLASH GLUCOSE MONITORING SYSTEM
Quick Start Guide for
FreeStyle Libre 14 day Reader
●
1
Assemble and Apply Sensor to the back of your upper arm
STEP 1
Select site on back of upper arm.
Do not use other sites as these are
not approved and may result in
inaccurate glucose readings.
Avoid scars, moles, stretch
Note:
marks, lumps, and insulin injection
sites. To prevent skin irritation,
rotate sites between applications.
STEP 4
Line up dark mark on Sensor
Applicator with dark mark
on Sensor Pack. On a hard
surface, press down firmly
on Sensor Applicator until it
comes to a stop.
STEP 7
Place Sensor Applicator over site
and push down firmly to apply
Sensor.
Do not push down on
CAUTION:
Sensor Applicator until placed
over prepared site to prevent
unintended results or injury.
Setup Overview
Refer to your User's Manual for full system instructions and information.
Reader
USB Port
Sensor
Pack
Codes on labels
must match
STEP 2
Clean site with alcohol wipe. Allow
site to dry before proceeding.
STEP 5
Lift Sensor Applicator out of
Sensor Pack.
STEP 8
Sensor
Gently pull Sensor Applicator
away from your body.
●
1
Touchscreen
Home Button
●
2
Sensor
Applicator
You can check your glucose whenever
CODE XXX you want for up to 14 days
XXXXXXXXXXX
YYYY-MM-DD
Peel lid completely off Sensor Pack.
Unscrew cap from Sensor Applicator.
CAUTION:
match on Sensor Pack and
Sensor Applicator or glucose
readings will be incorrect.
Assemble and Apply Sensor
to the back of your upper arm
Start new Sensor with Reader
Wait 60 minutes
for start-up
STEP 3
Cap
Lid
Sensor codes must
CODE
STEP 6
Sensor Applicator is ready to
apply Sensor.
Sensor Applicator
CAUTION:
now contains a needle. Do not
touch inside Sensor Applicator
or put it back into Sensor Pack.
STEP 9
Make sure Sensor is secure.
Discard used Sensor Applicator
and Sensor Pack according to
local regulations.
XXX
XXXXXXXXXXX
YYYY-MM-DD