Resetting the unit
If the unit stops responding while you are using it, you can reset the unit. Make
sure the unit is turned on, and then press the RESET button with the stylus.
The reset function will not work if the unit is turned off when you press the RESET
If the problem still persists after you have reset the unit, try the following (full reset)
The following procedure will cause all data on the unit to be lost and you must
restore data from your previous backup. However, any data added or modified
after your last backup will be lost permanently.
Turn off the unit
Remove the backup battery.
Remove the main batteries.
Wait for 30 seconds, then reinstall the main batteries and the backup battery.
Turn on and re-setup the unit using the H/PC Setup Wizard.
Restore your data from a backup.
If you forget your password, you must set up your unit again, using the above