Earthing; Finishing - Toshiba RAV-GM802ATW-E Installation Manual

■ For conforming to EMC standards, be sure to attach the supplied
clamp filter
<GM1102ATW, GM1402ATW>
Attach to the earth wire of the indoor/outdoor connecting wire.
Earth screw
Clamp filter
Indoor/outdoor
connecting wire
<GM1602ATW>
Attach to the three wires (1, 2, and 3) of the indoor/outdoor connecting wire.
Earth screw
Clamp filter
Indoor / outdoor
connecting wire
<GM802ATW, GM902ATW, GM1102AT8W, GM1402AT8W, GM1602AT8W>
No need to attach a clamp filter.
45-EN
Power supply wire
Power supply wire
– 23 –
8

Earthing

WARNING
Be sure to connect the earth wire. (Grounding work)
Incomplete earthing may cause an electric shock.
Connect the earth wire properly following applicable technical standards.
Connecting the earth wire is essential to preventing electric shock and to reducing noise and electrical charges on
the outdoor unit surface due to the high-frequency wave generated by the frequency converter (inverter) in the
outdoor unit. If you touch the charged outdoor unit without an earth wire, you may experience an electric shock.
9

Finishing

After the refrigerant pipe, inter-unit wires, and drain pipe have been connected, cover them with finishing tape and
clamp them to the wall with off-the-shelf support brackets or their equivalent.
Keep the power wires and indoor/outdoor connecting wires off the valve on the gas side or pipes that have no heat
insulator.
46-EN