Related Manuals for globalwater AquaWave AW-PRM-75-38-Q
Summary of Contents for globalwater AquaWave AW-PRM-75-38-Q
- Page 1 Premium Installation, Operation & Maintenance Manual Reverse Osmosis (RO) System AW-PRM-75-38-Q; AQ-PRM-75-38-Q-AGF All systems are equipped with Purefer ® series filters...
-
Page 2: Introduction And Warnings
INTRODUCTION AND WARNINGS ™ AquaWave Premium Reverse Osmosis System INTRODUCTION Congratulations on your purchase of the AquaWave™ Premium Reverse Osmosis System. The AquaWave Premium Reverse Osmosis System is designed with advanced filtration technology and utilizes a 5-stage filtration process to purify and deliver fresh-tasting water. This system is designed exclusively for municipal water systems and will remove volatile organic chemicals, chlorine, odor, sediment, suspended impurities, metals, and other harmful contaminants from your water. -
Page 3: Specifications
5 Stage Reverse Osmosis System OTHER IMPORTANT INFORMATION • Please note that the lifetime of the filters, as well as their replacement interval strongly depends on the inlet water quality, the amount of water consumed, the sediment and chlorine content, etc. System should be isolated from water supply if not used for more than 1 week. -
Page 4: Installation & Diagram
INSTALLATION & DIAGRAM ™ AquaWave Premium Reverse Osmosis System COMPONENTS • #9 Water leak detector • #10 Water leak detector replacement pellet • #1 1st stage filter - K14-PP-WW • #11 Pressure regulator set to 70psi/5bar • #2 2nd stage filter - K14-GT-WW •... -
Page 5: Installation Instructions
5 Stage Reverse Osmosis System INSTALLATION INSTRUCTIONS Install waste water clip If inlet water pressure is 60 psi / 4 bar, a pressure regulator must be installed and set at 60 psi / 4 bar. You must check and comply with all local plumbing codes. Fig. - Page 6 INSTALLATION MANUAL ™ AquaWave Classic Reverse Osmosis System INSTALLATION INSTRUCTIONS Prepare RO system for installation Install RO faucet Fig. 3 Fig. 4 air-gap faucet Fig. 4.1 • Locate the position to place the RO system Fig. 3 non air-gap faucet •...
- Page 7 5 Stage Reverse Osmosis System INSTALLATION INSTRUCTIONS Fig. 4.2 Fig. 4.4 non air-gap faucet • Connect this 1/4” white tube to compression filter components as shown in Fig. 4.2 (a) Fig. 4.5 • Insert compression filter assembly into base of threaded stem of faucet as shown in Fig.
- Page 8 INSTALLATION MANUAL ™ AquaWave Premium Reverse Osmosis System INSTALLATION INSTRUCTIONS Prepare RO system for installation - AIR-GAP FAUCET Prepare RO system for installation - continued Fig. 6.1 Fig. 5 installation diagram for non air-gap faucet • Connect the ¼” drain line to the smaller input barb on the air gap faucet.
- Page 9 5 Stage Reverse Osmosis System THE RO SYSTEM FULL CONFIGURATION WITH AIR-GAP FAUCET...
- Page 10 INSTALLATION MANUAL ™ AquaWave Premium Reverse Osmosis System INSTALLATION INSTRUCTIONS System start-up Prepare RO system for installation - continued • Ensure RO faucet is turned off/closed. Fig. 7 • Turn on main cold water supply valve and ensure that the 1/4”...
- Page 11 5 Stage Reverse Osmosis System THE RO SYSTEM FULL CONFIGURATION...
-
Page 12: Technical Data And Components
TECHNICAL DATA AND COMPONENTS ™ AquaWave Premium Reverse Osmosis System BEFORE CHANGING THE FILTERS OF YOUR RO SYSTEM • Turn off the 1/4" water supply valve. • Close the RO tank ball valve.. • Turn the RO faucet on so the water runs out of the system. Wait until there is no more water running. •... - Page 13 5 Stage Reverse Osmosis System FILTER CHANGE INTERVAL The suggested filter change interval is a non-binding recommendation based on years of experience. It represents the use of the RO system with an average inlet water quality and hence does not necessarily reflect the optimal filter change interval plan based on your water quality.
- Page 14 INSTALLATION MANUAL ™ AquaWave Premium Reverse Osmosis System FILTER IDENTIFIERS & TYPE • #1 K14-PP-WW: Inline PP Filter • #2 K14-GT-WW: Inline Activated Carbon Filter • #3 K14-BF-WW: Inline Activated Carbon Filter • #4 MTW-1812-75: Replacement RO membrane • #5 K12-GT-WW: Inline Activated Carbon Filter...
-
Page 15: Troubleshooting
5 Stage Reverse Osmosis System TROUBLESHOOTING Problem RO water looks "foamy" or "milky white" Possible Cause There is air in the system Air intake in the system is normal after the first installation. From time Possible Solution to time air might enter the systems through network. This condition will return to normal after a while. -
Page 16: Warranty
INSTALLATION MANUAL ™ AquaWave Premium Reverse Osmosis System WARRANTY Global Water Solutions (“GWS”) warrants the product will be free of defects in material and workmanship under normal usage conditions beginning on the date of manufacture and continuing for a warranty coverage period of 1 year. Warranty applies only when the product is used for its intended purpose and does not apply if a defect is due to improper use of the product, result of accident, misuse, or abuse. - Page 17 Have questions or need assistance? www.gwsusa.com rev 1 © 2023/07 gwsusa...
Need help?
Do you have a question about the AquaWave AW-PRM-75-38-Q and is the answer not in the manual?
Questions and answers