Securing A Child Restraint In A Rear Seat Position - Chevrolet Pontiac Wave 2007 Owner's Manual

3. Push and pull the child restraint in different
directions to be sure it is secure.
If the position you are
using has a head
restraint and you are
using a dual tether,
route the tether under
the head restraint and in
between the head
restraint posts.
If the position you are
using has an adjustable
head restraint and
you are using a single
tether, route the
tether under the head
restraint and in between
the head restraint
posts.
Securing a Child Restraint in a Rear
Seat Position
If your child restraint is equipped with the LATCH
system, see Lower Anchors and Tethers for
Children (LATCH) on page 56.
If your child restraint does not have the LATCH
system, you will be using the lap-shoulder
belt to secure the child restraint. Be sure to follow
the instructions that came with the child restraint.
Secure the child in the child restraint when and as
the instructions say.
If you need to install more than one child restraint
in the rear seat, be sure to read Where to Put
the Restraint on page 54. There is not room
for three child restraints in the rear seat, but you
can install two child restraints, one in each
rear outside seating position.
1. Put the child restraint on the seat.
2. Pick up the latch plate, and run the lap and
shoulder portions of the vehicle's safety belt
through or around the restraint. The child
restraint instructions will show you how.
63