During Operation; During Operation Safety; Starting The Engine - Toro Power Max 1432 OHXE Operator's Manual

During Operation

During Operation Safety

General Safety
•
Shut off the engine before unclogging the
machine and always use a stick or the
snow-cleanout tool (if provided).
•
Stay behind the handles and away from the
discharge opening while operating the machine.
Keep your face, hands, feet, and any other part
of your body or clothing away from moving or
rotating parts.
•
Never direct the discharge toward people or areas
where property damage can occur.
•
Use your full attention while operating the
machine. Do not engage in any activity that
causes distractions; otherwise, injury or property
damage may occur.
•
Exercise caution to avoid slipping or falling,
especially when operating the machine in reverse.
•
Always be sure of your footing, and keep a firm
hold on the handles. Walk; never run.
•
Exercise extreme caution when operating the
machine on a slope.
•
Do not operate the machine without good visibility
or light.

Starting the Engine

Using Electric Start
Note:
To use the electric starter (electric-start models only), connect a power cord to the plug-in first and then
to a power outlet. Use only a UL-listed, 16-gauge extension cord recommended for outdoor use that is not
longer than 50 ft (15 m).
WARNING
The electrical cord can become damaged, causing a shock or fire.
Thoroughly inspect the electrical cord before using the machine. If the cord is damaged, do
not use it. Replace or repair the damaged cord immediately. Contact an Authorized Service
Dealer for assistance.
CAUTION
If you leave the machine plugged into a power outlet, someone can inadvertently start the
machine and injure people or damage property.
Unplug the power cord whenever you are not starting the machine.
•
Look behind and use care when backing up the
machine.
•
When not actively clearing snow, disengage power
to the auger.
•
Exercise extreme caution when operating the
machine on or crossing gravel drives (2-stage
models only), walks, or roads. Stay alert for hidden
hazards or traffic.
•
Never attempt to make any adjustments while
the engine is running, except as directed in the
instructions.
•
After striking a foreign object, shut off the engine,
remove the ignition key (electric-start models
only), inspect the machine for damage. Repair any
damage before starting the machine.
•
If the machine starts to vibrate abnormally, shut off
the engine and check immediately for the cause.
•
Do not run the engine indoors; exhaust fumes are
dangerous.
•
Do not overload the machine capacity by
attempting to clear snow at too fast a rate.
•
Disengage all clutches and shift into neutral before
starting the engine.
•
Shut off the engine whenever you leave the
operating position, before clearing or unclogging
the collector, impeller, or discharge chute, and
when making any repairs, adjustments, or
inspections.
•
Never operate the machine at high transport
speeds on slippery surfaces.
10