Toro Workman 07369 Operator's Manual page 16

Key Switch
Use the key switch (Figure
the engine.
The key switch has 3 positions: O
Rotate the key switch clockwise to the S
to engage the starter motor. Release the key switch
when the engine starts. The key switch moves
automatically to the O
N
To shut the engine off, rotate the key switch
counterclockwise to the O
Hour Meter
The hour meter indicates the total hours of machine
operation. The hour meter
whenever you rotate the key switch to the O
or if the engine is running.
Horn Switch
The horn switch is located on the control panel
4). Press the horn switch to sound the horn.
Supervisor Switch
Move the supervisor switch
position and remove the key to prevent the use of third
gear when in the H
IGH
the shift lever moves to third gear when in H
Note:
The key is removable in either position.
Light Switch
Push the light switch (Figure
on or off.
Oil-Pressure-Warning Light
The oil-pressure-warning light
the engine-oil pressure drops below a safe level while
the engine is running.
Important:
If the light flickers or remains on,
stop the machine, shut off the engine, and check
the oil level. If the oil level is low, but adding
oil does not cause the light to go out when the
engine is started, shut off the engine immediately,
and contact your Authorized Service Dealer for
assistance.
Check the operation of the warning lights as follows:
1. Engage the parking brake.
2. Turn the key switch to the O
but do not start the engine.
4) to start and shut off
, O , and S
FF N
TART
position.
position.
FF
(Figure 5) starts to function
N
(Figure 4) to the S
range. The engine shuts off if
IGH
4) to toggle the headlights
(Figure 5) illuminates if
/P position,
N REHEAT
Note:
If the light does not function, either a bulb is
burned out or there is a malfunction in the
system that you must repair.
.
TART Note:
position
to 2 minutes for the light to come on.
Charge Indicator
The charge indicator illuminates when the battery
discharges. If the light illuminates during operation,
stop the machine, shut off the engine, and check for
possible causes, such as the alternator belt
Important:
broken, do not operate the machine until the
adjustment or repair is complete. Failure to
position
observe this precaution may damage the engine.
Check the operation of the warning lights as follows:
•
Engage the parking brake.
•
Turn the key switch to the O
(Figure
but do not start the engine. The charge indicator
and oil-pressure lights should glow. If any light
does not function, either a bulb is burned out or
there is a malfunction in the system that you must
repair.
LOW
Fuel Gauge
range.
The fuel gauge shows the amount of fuel in the tank.
It displays only when key switch is in the O
(Figure 5).
A single bar indicates a low fuel level and 1 flashing
bar indicates that the fuel tank is nearly empty.
USB Power Point
Use the USB power point
devices.
Important:
power point, insert the rubber plug to prevent
damage to the power point.
Choke Control
To start a cold engine, close the carburetor choke
by pulling the choke control
position. After the engine starts, regulate the choke
to keep the engine running smoothly. As soon as
possible, open the choke by pushing in the choke
control to the O
little or no choking.
16
The oil-pressure light should glow red.
If engine was just shut off, it may take 1
If the alternator belt is loose or
/P
N REHEAT
(Figure 4) to power mobile
When you are not using the USB
(Figure
position. A warm engine requires
FF
(Figure 5).
position,
position
N
4) out to the O
N