Options - AEG L 87480 FL User Manual

14 www.aeg.com
Off Mode (W)
The information given in the chart above are in compliance with the EU Commission regu-
lation 1015/2010 implementing directive 2009/125/EC.

7. OPTIONS

7.1 Start/Pause
Press button Start/Pause to start or
interrupt a programme.
7.2 Delay Start
With this option you can delay the start
of a programme from 30 minutes to 20
hours.
The display shows the related indicator
and delay time.
7.3 Time Save
With this option you can decrease the
programme duration.
• Press this button one time to set
'Shortened duration' for items with
daily soil.
• Press this button two times to set
'Extra Quick' for items with almost no
soil.
Some programmes accept
only one of the two options.
7.4 Extra Rinse
With this option you can add some rinses
to a washing programme.
Use this option for persons allergic to
detergents and in areas where the water
is soft.
The related indicator comes on.
7.5 Stains/Prewash
Press this button to add the stain and/or
a prewash phase to a programme.
Press the button again and again to
activate one or two options. The related
symbol and the indicator bar comes on
in the display.
0,05
Left On Mode (W)
0,05
• Stains: Use this option for laundry
with hard stains to remove.
When you set this option, put the
stain remover into compartment
This function increases the
programme duration.
This option is not
available with a
temperature lower than
40° C.
• Prewash: Use this option to add a
prewash phase before the washing
phase.
We recommend that you use this
option when you have laundry with a
high level of soil.
The set of this option
increases the programme
duration.
7.6 Spin
Press this button to:
• Decrease the maximum speed of the
spin phase of the programme.
The display shows only
the spin speeds available
with the set programme.
• Deactivate the spin phase.
• Activate the Rinse Hold function.
Set this function to prevent fabric
creases. The appliance does not drain
the water when the programme is
completed.
7.7 Temp.
Press this button to change the default
temperature. When the display shows
and , the appliance does not heat
the water.
.