This barrier pre- vents the microphone sound entries from being clogged by perspiration or makeup which would make the sound dull and reduce the sensitivity of the microphone. Therefore, never remove the moisture shield from the microphone! AKG C 555 L...
2 Interfacing The C 555 L is a condenser microphone and 2.1 Introduction therefore needs a power supply. Using any power supply other than those rec- Important! ommended by AKG may damage your micro- phone and will void the warranty.
(4) all the way into the respective wire loop below the opposite temple piece (1). (The cover (4) stabilizes the temple piece and prevents your hair from getting caught in the wire loop.) 5. Press the cable back into the cable holder (5). AKG C 555 L...
Refer to fig. 6. the points marked in fig. 6 and bend inward with extreme care. • Check whether the microphone fits better. If it does not, bend the wire some more, again with extreme care. AKG C 555 L...
Microphone Arm Fig. 8: Adjusting the microphone arm. Refer to fig. 8. 1. Unsnap the goose- neck (1) from the holder (2). 2. Snap the gooseneck (1) back into the holder (2) at the desired position. AKG C 555 L...
• To clean the microphone surface, use a soft Surface cloth moistened with water. 4.2 Windscreen • Clean the foam windscreen in mild soap suds. You can use the windscreen again as soon as it has dried. AKG C 555 L...
Distortion: 1. Gain control on the 1. Turn gain control mixer set too high. down CCW. 2. Mixer input sensitivity 2. Connect a 10-dB too high. preattenuation pad between microphone cable and input. Also read the transmitter and receiver manuals! AKG C 555 L...
Shipping weight: 260 g (9.2 oz.) This product conforms to the standards listed in the Declaration of Conformity. To order a free copy of the Declaration of Conformity, visit http://www.akg.com or contact sales@akg.com. Frequency Response Polar Diagram AKG C 555 L...
Need help?
Do you have a question about the C 555 L and is the answer not in the manual?
Questions and answers