Advertisement
Tetra
miniMAX
®
Components - Tetra
Tetra MiniMAX is also compatible with the following Tetra SNAP Rail components.
See https://products.gecurrent.com/led-signage-lighting for further details and install instructions.
1
2
3
6
Layout Modules
Before you begin, clean surfaces
1
and remove all debris from the
inside of the channel letter.Clean
the surfaces with a 50:50 mixture of
isopropyl alcohol (IPA) and water
and let dry.
Use rivets, screws, or electrical
4
grade RTV silicone to secure
at least every fifth LED module
within the channel letter. Use #6
(M3) pan headed metal screws,
1/8-inch (3.2 mm) rivets, or
electrical grade RTV silicone.
SNAP Accessories (optional)
®
4
5
7
Measure and cut Tetra LED strip
2
to the appropriate length for
each letter. Cuts can be made
between any of the modules.
Drill a 1/4-inch (6.4 mm) hole
5
near the LED strip and grommet
the hole for supply wire access.
NOTE: For halo-lit applications LED modules should be mounted on UL recognized
clear acrylic or polycarbonate. The light output from the LED system should be
directed back into the sign enclosure. This will allow for uniform backlighting of the
sign and will provide simple mounting.
Tetra SNAP Rail (GEDSRL08-3)
1
Tetra Snap SS Metal Clip (GESSMC-3)
2
Tetra SNAP Frame Endcap (GEDSFE-3)
3
Tetra SNAP Socket Endcap (GEDSSE-3)
4
Tetra SNAP Dual Rail Socket Cap (GESSDR-3)
5
6
Tetra SNAP T-connector (GEDSTC-3)
7
Tetra SNAP Interconnector (GEDSIC-3)
3
Installation Guide
Do not
press lens
Remove tape backing and stick LED
3
modules into place. When using
tape apply approximately 15 psi
pressure on the module (avoid the
lens dome surface) for 5 seconds,
full bonding strength after 24 hours.
Continue until you have reached the
end of the strip.
Remove all the debris from the
6
inside of the channel letter and
replace the sign face.
Advertisement
