Instructions For Attaching A Vesa-Compliant Arm - Sharp LL-173C Operation Manual

Instructions for attaching a VESA-compliant arm

An arm or stand based on the VESA standard
(commercially available) can be attached to the
monitor. Procurement of the arm or stand is at the
customer's discretion.
Arms or stands able to be used
Attachments must satisfy the following.
- Compatible with the VESA standard.
- Have a gap of 100 mm x 100 mm between the
screw holes on the section to be attached.
- Not be likely to fall off or break off after being
attached to the monitor.
How to attach the arm or stand
- Be careful not to over bend the cable or add
extension cords as this could lead to malfunction.
- While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or stand.
CAUTION!
- Be careful not to get your fingers pinched
between the display and stand nor to let the
stand drop. These could lead to injury.
- Do not cover or block the vents and openings
since insufficient ventilation can cause
overheating.
1. Remove the cables.
2. Spread out a soft cloth on a flat surface.
3. Being careful not to damage the monitor, gently
lay the monitor on it display-side down.
4. Remove the base. (p.10)
5. Remove the four screws and then remove the
stand from the monitor.
Notes:
- The stand and base are specially made for use
with this monitor. Once having removed the
stand, never attempt to attach it to another
device.
- Once having removed the screws, store them
together with the stand and base. If the stand is
ever re-attached, be sure to use the original
screws. Using different screws could lead to a
malfunction.
6. Attach the arm to the monitor with the four screws.
Note:
- The screws used to attach the arm should be M4
screws with a length of 7 mm - 9 mm (0.28"-
0.35") protruding from the surface to be attached.
Using different screws could cause the monitor
to fall off or to be internally damaged.
7 mm - 9 mm (0.28"- 0.35")
Screw used to attach arm
Arm
Part of monitor to which arm is
attached
28