Mode* Button - VESPA GTS 300 i.e. ABS 2018 Manual

Press the MODE briefly to cycle through the modes and select TOTAL odometer
mode, then turn the ignition switch to OFF.
Turn the ignition switch to ON while pressing and holding the MODE button.
Release the MODE button for 2 to 4 seconds.
WARNING
TO GO FROM «KM» TO «MILE» THE MULTIFUNCTION INDICATOR «C» MUST
BE SET TO TOTAL ODOMETER (TOTAL).
CAUTION
FOR SAFETY, THIS SELECTION PROCEDURE IS ONLY PERMITTED AT A VE-
HICLE SPEED OF 0 KM/H.

*MODE* button (01_08)

Press the MODE button briefly and release to cycle through the following display
functions:
•
Total Odometer (TOTAL)
•
Trip odometer A (TRIP A)
•
Trip odometer B (TRIP B)
Press and hold the MODE button to:
•
access the clock settings from the TOTAL odometer screen.
•
reset the relative odometer reading in the TRIP A or TRIP B trip odometer
01_08
screens.
N.B.
IN THE NAVIGATION OF THE DISPLAY ARE DEFINED:
- «BRIEF PRESS»: A PRESS OF THE INDICATED BUTTON, FOR A PERIOD OF
LESS THAN TWO SECONDS;
14