Table of Contents
Advertisement
en Installation instructions
2.4 Shield
If the base of the hotplate can be touched, fit a protecting shield.
¡ The shield must be at least 10 mm from the lowest
part of the hotplate and must be capable of with-
standing the appliance temperatures. Minimum
thickness of worktop is 30 mm.
¡ The shield material must be mdf or similar with min-
imum thickness of 12 mm.
¡ The shield overall dimensions must be 560 mm
wide x 480 mm deep.
¡ Provide cutout in right hand rear of shield of 80 mm
wide x 80 mm deep to provide for gas regulator /
LPG connection fitting.
¡ After installation of the shield the clearance around
the top and sides of shield will allow adequate vent-
ilation. Ensure the side and top clearances are not
obstructed.
2.5 Positioning the appliance
Note: Do not use silicone to bond the appliance to the
worktop.
Position the cooktop with the upper side facing
1.
down on a flat, stable surface.
Apply the adhesive seal supplied to the lower edge
2.
of the cooktop. The adhesive seal prevents the pen-
etration of liquids.
8
Screw the brackets supplied into the specified posi-
3.
tion so that they can turn freely.
Turn the cooktop around and insert it into the re-
4.
cess. Insert the cooktop in the front of the recess.
Advertisement
Table of Contents
