Hobbytech 6WD CRX18 FLAT CAGE Instruction Manual page 6

• Mode B : In this mode, the turn signal light is in a slow flashing state when the model car makes a turn; When braking, the
stop light is in a high-light state, and when not braking, it is in a low-light state;
The headlight is in a high-light state; The tail light and fog light are in off state.
• Mode C : In this mode, the turn signal light is in a continuously slow flashing state regardless of whether the model car
makes a turn or not; When braking, the stop light is in a high-light state, and when not braking, it is in a low-light state; The
headlight is in a high-light state; The tail light and fog light are in on state.
• Mode D : In this mode, the turn signal light is in a slow flashing state when the model car makes a turn;
When braking, the stop light is in a high-light state, and when not braking, it is in off state; The headlight is in off state; The
tail light and fog light are in on state.
Notes:
1. The CH4 channel of the receiver can output both the light mode signal and the PWM signal. It needs to be set at the
transmitter side. Press the CH4 button on the transmitter for a short time, the CH4 channel outputs the light mode. Each
time it is pressed,one mode per press (Default Mode, Mode A,
Mode B, Mode C and Mode D are switched in turn); Press and hold the CH4 button for a while,then switch the CH4 channel to
PWM output.
2. Every time the receiver is turned on, the car light control mode is in Default Mode.
3. Mode C is an emergency light working state. In this mode, the left and right turn signal lights flash synchronously and slowly
as emergency lights.
4. This receiver identifies the neutral positions of Steering CH1 and Throttle CH2 automatically when it is powered on. It
recommends to power on the receiver again after the trims of the transmitter are turned.
CHARGING THE BATTERY
1. Connect the charger to a USB port then connect the battery to the charger.
2. When charging, the status LED is red, when charged, the status LED is green.
3. Do not let the battery charge unattended!
4. If the battery or charger is hot, disconnect the battery and charger immediately as this may be caused by an internal short-circuit.
2. Connect the battery to the charger.
ESC FUNCTION INSTRUCTIONS
1.Connect related equipment
• Make sure the ESC is off before connection. Connect the motor with
M+ and M- of ESC. Connect the steering servo to the 3Pin interface
marked with «ST» of ESC (- + S connected correspondingly).
Connect the battery with the positive and negative poles of ESC
correspondingly.
2.Normal boot, identification throttle midpoint:
• After connecting related equipment as step 1, turn on the radio first,
move the throttle trigger to the neutral position. Turn on the switch of ESC at last. The receiver will automatically recognize
the battery type when it is powered on again. Then it can run it.
Notes:
a. The ESC can be run after completing self-inspection (about 3 seconds) if power on, otherwise it cannot
be operated normally.
b. If there is no power output and the red light of ESC flashes quickly after power on, please check whether the throttle trim of the
transmitter is set to the «0» position, the receiver will automatically recognize the midpoint of the trim throttle after restarting;
1. Connect the charger's USB port to a power source.
Battery
6
LED
Servo
ESC & receiver
Motor