Advertisement
4. OPERATION
4.1.
Connect the USB lead to the rear of the lamp. Plug into USB power supply and turn on, the charging LEDs on the lamp will flash
green to show that charging has commenced.
4.2.
The number of green lights flashing indicate the level of charge.
4.3.
When the battery has charged fully all the LEDs will show steady green.
4.4.
Direct the lens away from your eyes before switching on.
4.5.
Toggle the lamp between the end light and side light using the ON/OFF switch.
4.6.
The output of the side LED can be varied by pressing the switch a further time.
4.7.
The lamp may be suspended by the hooks or attached to any ferrous surface by using the magnets. When the light is hanging from
the hook it can be rotated through 360° for more precise positioning.
4.8.
Separate the top and bottom sections by pulling apart. When attached to a ferrous surface, using the base magnet, the lamp can
be rotated to shine in any direction.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product
becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and
dispose of the product and fluids according to local regulations.
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
BATTERY REMOVAL Remove 6 screws on back of lamp. Remove rear casing and disconnect the wiring from the circuit board. Remove
battery and dispose of according to local authority guidelines.
Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products
containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme. Jack
Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
sales@sealey.co.uk
Original Language Version
fig.1
www.sealey.co.uk
LED360PLUS.V2 SERIES
Issue 3 (3,F)
REGISTER YOUR
PURCHASE HERE
25/04/23
Advertisement
