Slide Out Chassis - Scotsman NS650 User Manual

NS650
REMOVAL AND REPLACEMENT: Slide Out Chassis
////////////////////////////WARNING///////////////////////////
Disconnect Electrical Power from Machine
Before Proceeding with Removal of
Components.
//////////////////////////////////////////////////////////////////////////
Moving the ice making chassis
out may aid in gaining access to
certain components for service.
The top panel must be
accessible in the installed
location in order to slide out
the chassis.
1. Remove the top panel.
2. Remove the lower left front
panel, the ice access door, the
upper left front panel, and the
cross brace between the upper
& lower front panels.
3. Shut off the water supply,
and disconnect the water line at
the strainer inlet.
4. Check that the electrical
power is OFF, and disconnect
the spout switch leads from the
spout switch.
5. Pull up and remove the ice
level sensors from the ice chute.
6. Unscrew three hex studs,
and remove the ice chute cover.
7. Unscrew the ice sweep, and
remove it.
8. Loosen the band clamp
under the ice chute, and lift up
and remove the ice chute from
the evaporator.
9. Disconnect drain system
from reservoir and drip pan.
10. Remove control box cover,
disconnect incoming electrical
leads and pull leads & conduit
from the control box.
11. Remove chassis retaining plate from the
front of the chassis.
12. Slide the chassis out to access the
components.
ICE SWEEP
WATER
COOLED
CONDENSER
CONNECTIONS
December, 1988
Page 22
WATER COOLED
BAND CLAMP
RETAINING
PLATE